BMI Racing "Copperhead 12" discussion and support
#1053
Tech Fanatic
#1063
Hey Guys,
I just finished making some optional standoffs for under the hinge pin block for high bite. Pretty much, it is 2mm taller than the stock ones. They are threaded standoffs. A set screw now will go into the pivot ball, the standoff threads onto the set screw and then you hold the hinge pin block on by threading the 2 4-40 screws into the standoffs. I figured it would be a nice option for those who want to shim high without stacking a bunch of shims. The new standoff kit will include the standoffs,2 4-40 x 5/16 set screws and 2 4-40 x 1/4 flathead screws. I will get them on the website today or tomorrow.
I just finished making some optional standoffs for under the hinge pin block for high bite. Pretty much, it is 2mm taller than the stock ones. They are threaded standoffs. A set screw now will go into the pivot ball, the standoff threads onto the set screw and then you hold the hinge pin block on by threading the 2 4-40 screws into the standoffs. I figured it would be a nice option for those who want to shim high without stacking a bunch of shims. The new standoff kit will include the standoffs,2 4-40 x 5/16 set screws and 2 4-40 x 1/4 flathead screws. I will get them on the website today or tomorrow.
#1064
Tech Champion
iTrader: (31)
Here's a video of my local carpet track Hangar 30....and of all of us R/C geeks
http://www.youtube.com/watch?v=B0OiV...layer_embedded
http://www.youtube.com/watch?v=B0OiV...layer_embedded