Tower Hobbies Cutback 1/10 4x4 Short Course Truck
#301
Tech Initiate
I used 125k in the center diff.
#302
Been busy and haven't kept up in a few days, but...
Tonight after work, I changed to the optional 54t spur gear and went up 2 teeth on the pinion. Now my gearing is 13/54.
I'll test it out tomorrow/today depending on what everyones time zone is.
Tonight after work, I changed to the optional 54t spur gear and went up 2 teeth on the pinion. Now my gearing is 13/54.
I'll test it out tomorrow/today depending on what everyones time zone is.
#303
Tech Rookie
That's exactly what I'm running, Its Much FASTER!!!
I need to pick up a 17 pinion and give that a try.
#304
I'm running the 17 pinion with motor temps about 148 150
#305
The other day the back right wheel started bouncing like crazy and at the same time the rear end is really bouncy is the a broken diff or rear gear box? Ty
Last edited by amospetrie; 01-23-2016 at 02:34 PM.
#306
Tech Champion
Sounds like a wheel balance issue. Try switching the wheels left to right and see if the problem follows the wheel or stays on the same side. Also check hub bearings, axle bent, drive pins coming out and hitting something, etc.
#307
Ty I'll try that tomorrow but nothing seems to be bent
#308
That out of the way..
It was like night and day. The truck screamed across my yard and tore things up. Much better. I am pleased.
#309
#310
Tech Initiate
Finally tried it on 3s with the 17/54 gearing. It moves! But like it's been mentioned, the esc is programming is a little weird on 3s. It's almost like turbo lag, it goes like it's at full throttle on 2s, then just goes again, like enough to ovalize the tires again fast.
Only did a few mins, motor was hot, had already dumped a 2s through it. Couldn't keep my finger on the motor for more than 3-4 seconds.
Only did a few mins, motor was hot, had already dumped a 2s through it. Couldn't keep my finger on the motor for more than 3-4 seconds.
#311
I bet it flew on 3s.
I am happy on 2s after chaning the gearing to 13/54.
I am happy on 2s after chaning the gearing to 13/54.
#312
Tech Initiate
#313
Maybe I will.
#314
Tech Initiate
Well I let the magic smoke out....
Last edited by java230; 02-01-2016 at 07:47 AM.
#315
How many runs did you get before this happened?
Mine did it seconds after plugging in and prepping to run this truck for the first time. (same day it arrived)
Mine did it seconds after plugging in and prepping to run this truck for the first time. (same day it arrived)