Durango DEX210 Thread
#2896
Tech Regular
sounds like yeti should make some for the 410 next :d
#2898
My new front end for the DEX210
4mm Carbon fibre and aluminium mounts
4mm Carbon fibre and aluminium mounts
Last edited by Cream; 12-21-2011 at 02:25 PM.
#2899
I Do have a question...
The drive Cups seem pretty sloppy where the dog Bone Goes In, meaning, The move in and out at the bearings at the upright.... i was afraid the Pins on the axle would fall out...
I placed a Little piece of Fuel tiding inside the cup to help tighten it up... but those fell out..
Did i miss something in the Manual???
Stav
The drive Cups seem pretty sloppy where the dog Bone Goes In, meaning, The move in and out at the bearings at the upright.... i was afraid the Pins on the axle would fall out...
I placed a Little piece of Fuel tiding inside the cup to help tighten it up... but those fell out..
Did i miss something in the Manual???
Stav
Please guys.... Need ta figure this one out .... all the expert help is appreciated
#2909
Tech Lord
iTrader: (52)
The drive Cups seem pretty sloppy where the dog Bone Goes In, meaning, The move in and out at the bearings at the upright.... i was afraid the Pins on the axle would fall out...
I placed a Little piece of Fuel tiding inside the cup to help tighten it up... but those fell out..
Did i miss something in the Manual???
I placed a Little piece of Fuel tiding inside the cup to help tighten it up... but those fell out..
Did i miss something in the Manual???
#2910