387LikesJConcepts Thread
03-18-2014, 12:10 PM
#7396
Do they make other popular 1/8th tires in Silver compound? I do not know anything about the 1/8th side of tires, but what I have noticed is they release the two most common compounds first, then if the tire is a great success open up more compounds to it.
Prime example the Splitter started in Green only and now I believe is available in Black, Blue, and Green compounds.
Prime example the Splitter started in Green only and now I believe is available in Black, Blue, and Green compounds.
03-18-2014, 09:24 PM
#7397
Hey funny question but I have the Nissan SCT body. In the directions it shows what "dimples" to ream for the mounting on a sc10. They are the same location for the sc10.2 correct? I know it is a dumb question but I just want one set of holes. Thanks for the info!!
03-19-2014, 05:49 AM
#7398
No, but the RC8.2 Silencer body fits if using one of the lower profile batteries.
I don't know; will have to look into that one.
Distributor orders shipped out last week. We are scheduled to have more the end of this week and I've seen orders going out daily; so you might want to call us directly 
.
Not at the moment.
Yes; its the same mounting location.
since we're on the topic, will 1/8th dirt webbs (or barcodes) be available in silver compound? Gold's seem to take foreveeerrr to break in.
Sorry if it has been asked over and over. Is there an ETA on dirtwebs to be back in stock.
Thank you
Thank you
.
How about 10th scale Truck Dirt Webs?
Hey funny question but I have the Nissan SCT body. In the directions it shows what "dimples" to ream for the mounting on a sc10. They are the same location for the sc10.2 correct? I know it is a dumb question but I just want one set of holes. Thanks for the info!!
03-19-2014, 07:49 AM
#7400
ETA on the midmotor stadium truck finnisher?
03-19-2014, 07:53 AM
#7401
03-19-2014, 08:03 AM
#7402
03-24-2014, 08:50 AM
#7404
Has anyone tried webs in 2WD SCT? I have a full set of golds and wondered if I should just run them up front or in all four. I have been running the pressure points in front and codes in back until now.
03-24-2014, 09:05 AM
#7405
DWebs on all 4 is a very balanced setup on my local indoor track. If you find the front end biting a little too hard go back to the Pressure point fronts.
03-24-2014, 09:15 AM
#7406
Thanks Randy!
03-24-2014, 05:40 PM
#7407
Tech Apprentice
Dirt Webs
Just found out Dirt Webs "were" in stock at my local shop. (RC Country in Sacramento) I might have went a little nuts.
03-25-2014, 10:17 PM
#7409
Tech Master
iTrader: (27)
Join Date: Dec 2003
Location: im 4rm a far away place called 1st
Posts: 1,849
Trader Rating: 27 (100%+)
is there an eta on the new rims and tires for 1/10 buggy (bullet)? saw some floating around at OCRC on monday and looking good.
03-26-2014, 05:51 AM
#7410
What difference do you notice between the Hybrid and Metrix tires? IE: Fwd and side bite.