My New Mini Inferno info web site!!!
#16
Tech Apprentice
The cup joint is where the dogbones sit in. When you go brushless you will also need some new hub bearings, because the plastic bushing cannot go as fast a brushless and will put too much strain on the cup joints. When you go to www.half-8.com , make sure too search for past posts, because that is where most of the information is.
#18
Ah ok i see,
I'm just wondering about the number of Nimh i could use on the mamba systems,
I keep reading 4 cell but still believe that it might be too much..
I was thinking 1 scale down to about 12.3 volt or 13.5 volt.
Nimh are great to use, although a bit heavy, i was going to make like a connector, which would allow me to remove and add cells as i wish to the pack, (like lego )
I'm just wondering about the number of Nimh i could use on the mamba systems,
I keep reading 4 cell but still believe that it might be too much..
I was thinking 1 scale down to about 12.3 volt or 13.5 volt.
Nimh are great to use, although a bit heavy, i was going to make like a connector, which would allow me to remove and add cells as i wish to the pack, (like lego )
#23
Thats what i was thinking,
I've had the charger for quite a while now,
It just seems to be hitting FULL charge status WAY too soon
The swallow 2 would be good,
No need for a power supply and I can charge up the lipo when i get it.
I will test these batts and decide from there to use lipo i think too!
I've had the charger for quite a while now,
It just seems to be hitting FULL charge status WAY too soon
The swallow 2 would be good,
No need for a power supply and I can charge up the lipo when i get it.
I will test these batts and decide from there to use lipo i think too!
#24
I'm currently developing a 3 stage setup guide
PIMPED OUT
PERFORMANCE ORIENTATED
BUDGET BUGGY!
It will have a how to on what parts and where to get them.
I'm also going to have a competition for the mini inferno guys,
its either going to be the MOST ORIGINAL BODY SHELL
or
MOST HOPPED UP MINI INFERNO!
Should be a bit of fun!
PIMPED OUT
PERFORMANCE ORIENTATED
BUDGET BUGGY!
It will have a how to on what parts and where to get them.
I'm also going to have a competition for the mini inferno guys,
its either going to be the MOST ORIGINAL BODY SHELL
or
MOST HOPPED UP MINI INFERNO!
Should be a bit of fun!