PROTOform Race Bodies
#376
Once sales for a part # fall below a certain threshold we are forced to discontinue them due to all the space needed to inventory the product. We only have so much space, and unfortunately the BMR line of bodies never caught on to stay above the chopping block.
We will have something new for 1/12 in the near future. Until then, our AMR and Strakka cover most 1/12 needs.
We will have something new for 1/12 in the near future. Until then, our AMR and Strakka cover most 1/12 needs.
#377
Tech Fanatic
Where does the D9 fit into the handling spectrum?
#378
Suspended
#379
Super Moderator
iTrader: (239)
#380
I am just here to say that ProtoForm customer support is the bomb! I had a defect on a new body and they squared it away, like a boss!
/happyrant
/happyrant
#381
Will the Type S body start to come with your new wing hardware or is just the D9?
And how thick is your TS-18 pre-cut wing couldn't see it listed?
And how thick is your TS-18 pre-cut wing couldn't see it listed?
Last edited by Bar; 10-23-2018 at 03:03 AM.
#384
#385
Tech Rookie
Once sales for a part # fall below a certain threshold we are forced to discontinue them due to all the space needed to inventory the product. We only have so much space, and unfortunately the BMR line of bodies never caught on to stay above the chopping block.
We will have something new for 1/12 in the near future. Until then, our AMR and Strakka cover most 1/12 needs.
We will have something new for 1/12 in the near future. Until then, our AMR and Strakka cover most 1/12 needs.
#386
Tech Fanatic
spectrum. See attached handling spectrum.
#387
Tech Fanatic
iTrader: (2)
My FOREVER dream is that Protoform would develop a modern 1/12th scale LMP1. Well..., scale as much as is aesthetically and aerodynamically possible.
There have been some beautiful 1/10th scale examples produced over the past couple years by some other sources, but no one has attempted 1/12th.
There have been some beautiful 1/10th scale examples produced over the past couple years by some other sources, but no one has attempted 1/12th.