R/C Tech Forums - View Profile: ScottE1776

Go Back  R/C Tech Forums > Members List
Reload this Page >

ScottE1776's Profile

ScottE1776 ScottE1776 is offline

Tech Regular

About Me

  • About ScottE1776
    One of the very first RC racers in Tucson. My Brother and I started in 1974
    Mesa, AZ
    Cowboy Shooting, RC, Fencing


Total Posts
Visitor Messages
General Information
  • Last Activity: 04-16-2024 01:45 PM
  • Join Date: 07-07-2013
  • Referrals: 0


Showing Friends 1 to 10 of 10

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. 07-25-2013 03:31 PM - permalink
    No problem, I was shocked to find such a low roll out but ended up with the fastest laps in the main so it can't be to far off. I too was shocked at the gearing on the brushless motors, it seems that the hottest modifieds are running what we use dto run with stock motors.
  2. 07-24-2013 09:41 PM - permalink
    We typically talk rollout when asking about gearing for foam tired pan cars. I had 42mm tires, with a 48 pinion and a 76 spur. This equates to (76/48)*3.14159*42 which is 83mm of rollout. I am running a Speed Passion 1 cell 17.5 set at 20 degrees of timing. The current SP motor is the MMM and I would gear it the same with the same timing. I honestly thought I was closer to 90mm on rollout and will likely be trying it on Sunday, my first run with the car had the axle to tight on the bearings which caused heat. I geared down before finding the tight axle and never geared back up.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Your Privacy Choices -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.