139LikesSerpent SRX-8 Nitro buggy
03-29-2016, 03:34 AM
#46
Serpent has some of the best made parts but ....that radio tray looks like it going to be hard on the carb. Look at the angle its pulling on the throttle body. They should have found a way to move that servo back at least another inch, so it would pull out at a less of a angle. Not trying to bash Serpent but looking at that layout.....just looks wrong.
03-29-2016, 03:47 AM
#47
Serpent has some of the best made parts but ....that radio tray looks like it going to be hard on the carb. Look at the angle its pulling on the throttle body. They should have found a way to move that servo back at least another inch, so it would pull out at a less of a angle. Not trying to bash Serpent but looking at that layout.....just looks wrong.
03-29-2016, 05:08 AM
#48
The new buggy has a similar look to the current competition out there. Does anyone know what demensions are those front bearings they look small..... Those new hubs look really nice though. The older buggy was great, imo, but really like the new style points that Billy put into the car.
This battery will work http://www.amainhobbies.com/rc-cars-...00-l-2s/p15789
Serpent has some of the best made parts but ....that radio tray looks like it going to be hard on the carb. Look at the angle its pulling on the throttle body. They should have found a way to move that servo back at least another inch, so it would pull out at a less of a angle. Not trying to bash Serpent but looking at that layout.....just looks wrong.
03-29-2016, 07:14 AM
#49
For diff bearing, what size? Is it flanged? Center/front/rear?
03-29-2016, 07:16 AM
#50
03-29-2016, 09:21 PM
#51
03-30-2016, 02:38 AM
#52
From the teaser, i think only standard ackerman can fit. Is the old option 2 or option 3 ackerman applicable to srx8? I really dont like the option 1
03-30-2016, 02:45 AM
#53
Tech Regular
Ackermann is changed by changing the carbon steering parts L and R.
Last edited by crd; 03-30-2016 at 02:58 AM.
03-30-2016, 11:05 PM
#54
Tech Adept
Will there be an updated truggy in the mix that will have some of these improvements ?
03-30-2016, 11:23 PM
#55
Will they keep the rear upright boot (prevent dust) for cvd and add the front 1. I think it be will nice
03-31-2016, 05:22 AM
#56
yes, front ones too!
03-31-2016, 03:37 PM
#57
Tech Initiate
hey hey !!!!
Before any announcement, i found this page !!!
promo.serpent.com/srx8/
add http.... before the word promo
Before any announcement, i found this page !!!
promo.serpent.com/srx8/
add http.... before the word promo
03-31-2016, 04:55 PM
#58
Anyone tested the new buggy? Is the handling characteristics changes a lot?
04-01-2016, 03:26 AM
#59
