The AE FActory Team B44.2 Thread
#1547
Thanks man. I assure u iam far from lazy. But def impatient. Ha. I have like 12 windows open looking for stuff for this. Anything I should get before the build. I already have the rpm cups. Running tekin rs pro with a gen 2 7.5. 1015 servo.
#1551
Tech Lord
iTrader: (22)
Looks pretty good to me and all the weight is as far back as possible. Rigor runs his over the top so battery change is one step faster. He does not have to unplug the battery to replace it. And he wont have to pull the slipper assy. past any wires which is quicker if he has to pull the slipper. I do mine the same way you do.....
BTW the carbon sticker looks awesome. You should put some on the battery hold down....
BTW the carbon sticker looks awesome. You should put some on the battery hold down....
#1552
Tech Lord
iTrader: (22)
Clean is tuff on a44.
I put some servo tape down 1st. Stick my wires to it then I put some over the wires. Keeps them from flopping all over. I could take more time I guess. I do have some fancy clips I could use which may be cleaner.
Its all hidden once the motor is on anyway.
I put some servo tape down 1st. Stick my wires to it then I put some over the wires. Keeps them from flopping all over. I could take more time I guess. I do have some fancy clips I could use which may be cleaner.
Its all hidden once the motor is on anyway.
#1554
Clean is tuff on a44.
I put some servo tape down 1st. Stick my wires to it then I put some over the wires. Keeps them from flopping all over. I could take more time I guess. I do have some fancy clips I could use which may be cleaner.
Its all hidden once the motor is on anyway.
I put some servo tape down 1st. Stick my wires to it then I put some over the wires. Keeps them from flopping all over. I could take more time I guess. I do have some fancy clips I could use which may be cleaner.
Its all hidden once the motor is on anyway.
#1556
Tech Lord
iTrader: (22)
Heat shrink / route all wires together, then a little dab of CA glue on the tip of a razor blade, pin it down to the chassis. This keeps dust / dirt from accumulating on servo tape too. It can super clean if you have the right stuff, and want to take the time and effort. Most of ours I've seen are good enough
#1557
I dont know what batteries you guys are running but my saddles packs are connected by a jumper wire with bullet connectors. To take the pack out just take one side out and unplug the bullet and then the other side comes out.
#1558
TLR 22 wheels on b4/44 are fine. Certain b4/b44 wheels on the TLR don't fit right though. Not wide enough at the axle and leaves a gap.