rayhuang

iTrader: (5)

pucho-on the Warpspeed Xray Chassis-Vic wants me to handle all the sales and distribution of the Warpspeed Xray. If I get enough interest-I will actually have them in inventory. If racers only buy them one every few weeks-I'll do them per order (about two week turn around time).

ultrgraphics-I am still working on pricing and may only sell it as a kit (top and bottom deck together).

Ray

pucho

OK, Ill make sure I send them your way


HUMMM! not to realy, other than the short arms, and the bulkheads all the other stuff is the same, the diffs and the layshaft where lightened but believe me that din't make a huge inpact. If you wan't to call the huge chunk of weight running down the middle of the car an upgrade then do so.

rayhuang

iTrader: (5)

pucho-I am coming to the bird. I am rooming with Hector (OHH NOOOooooooooooooooooo!!!!!!)

Keep him under control would ya?

dr_hfuhuhurr

iTrader: (95)

Ray,
Let me know the price. I'd like an upperdeck as well.

Blake

pucho

Just don't feed him any beans! waint hold up don't feed him at all!! Im going to try and race the Club race on WED night. I have to stay at our track as my GM and Service Manager are both going to be racing.

dr_hfuhuhurr

iTrader: (95)

Anyone know if this part number will fit the XRay?

Losi Thrust Bearing A3098

http://horizon.hobbyshopnow.com/prod...?prod=LOSA3098

rayhuang

iTrader: (5)

pucho-is RPM speedway a carpet/foam track or a carpet/rubber track? I wish I could come early enough to do the RPM race on Sunday. I will be arriving Tuesday night or Wednesday morning.

Bobby Llantin

Hey man whats up. Just wondering where your new track will be located also, is it carpet. My dad, and i are looking at going to the birds as of now the only problem its during a school week.

talk to later
Bobby Llantin

sands

Why do you need to replace the trust bearing in the diff?

dr_hfuhuhurr

iTrader: (95)

I was going to rebuild the diffs and thought I'd throw in a new set of thrust bearings.

Blake

pucho

I don't think it will work.


It will be carper, foams (indoor) offroad and asphallt outside. Maybe when you guys take a break you can shoot up and check it out.

Bobby: We are in caselberry next to the Sams about 2 miles from superior.

sands

The best thing you can do for the thrust bearing is to lap the plates - same goes for the diff rings.

Use 600-800 grit wet/dry sand paper from your local car parts store. Put it on a flat (glass) surface and rub them in a figure 8 until there is no shiny left. This will make them very flat and run smoooooth.

jiggamacdaddy

hey its bobby how big is the track?

pucho

Aprox 100x60 we are using the new ozite that was used in Cleveland.

alien too

iTrader: (1)

Pucho - How do you believe the Fr. solid diff works on carpet with foams vs. Fr diff?