Tekin RS ESC sensored
#7111
Tech Master
iTrader: (18)
I downloaded it straight from here: http://www.teamtekin.com/hotwire.html
Hotwire is plugged into the USB.
I get the error when I click on the Hotwire Image to start the Application.
When I click the application Windows pops up with this exact error. " Hotwire is not working. Windows is checking for a solution.. "
I'm uninstalled about 5 times now, both trying to install after restarting, with USB plugged in, without USB plugged in. I've tried the Hotwire Restore application as well..
I even tried installing Microsoft .NET 2.0 and Microsoft Windows Installer 3.1, both not compatible with my x86 system. and I did install the Microsoft MDAC 2.8 . all via the Tekin website.
Hotwire is plugged into the USB.
I get the error when I click on the Hotwire Image to start the Application.
When I click the application Windows pops up with this exact error. " Hotwire is not working. Windows is checking for a solution.. "
I'm uninstalled about 5 times now, both trying to install after restarting, with USB plugged in, without USB plugged in. I've tried the Hotwire Restore application as well..
I even tried installing Microsoft .NET 2.0 and Microsoft Windows Installer 3.1, both not compatible with my x86 system. and I did install the Microsoft MDAC 2.8 . all via the Tekin website.
#7112
So I pulled out my DB12RR to get it ready for the next race and decided to clean up the wiring. I shortened the servo and speedo wire to the receiver. While doing this I noticed that the deans plug could be soldered right on to the solder post on the Tekin RS.
#7114
I downloaded it straight from here: http://www.teamtekin.com/hotwire.html
I even tried installing Microsoft .NET 2.0 and Microsoft Windows Installer 3.1, both not compatible with my x86 system. .
I even tried installing Microsoft .NET 2.0 and Microsoft Windows Installer 3.1, both not compatible with my x86 system. .
#7120
is there any chance for a tiny programmer like this in near future ???
#7122
#7123
#7124
Not much. Give me a call tomorrow when you get time. I've got a question for you.