Mugen MTC1
|
|||
#1516
Tech Elite
iTrader: (30)
Xray:
2.6, 2.7, 2.8, and 2.9 would be good to have on hand. If you want the progressive ones, the 2.3-2.6 and 2.5-2.8 are what xray has. I'm mostly around the 2.6 all around or 2.6 front and 2.7 rear at the moment, or that's what's currently on the cars anyway.
SMJ:
They are a bit cheaper to get and do now have some rates that are a lot closer to what xray has.
Red progressive front and blue rear was what I had ran last on those, and they were ok. I have ran the red progressive front and yellow progressive rear before and they were good in USGT, was going to try the yellow front and red rear setup, but didn't get around to it.
Axon:
i haven't ran this brand, but have looked at what they have, and they do seem to have a much finer set of spring rates from when compared to the other two.
for example they have 2.5, 2.6, 2.7, and such like Xray and now SMJ do, but Axon also has 2.55, 2.65, 2.75, and such that fall between the rates. Don't know if they're good or not, but I could see the finer rates being worth trying.
#1517
The rear spring smj blue is hard than yellow ?
#1518
The springs fronf and rear are simile?
#1519
Can you give me cod. number or link where I can buy spring smj red ....yellow....blue for mugen mtc1
the smj spring for mugen is short or long?
the smj spring for mugen is short or long?
Last edited by tom1974; 05-30-2019 at 03:19 PM.
#1520
Tech Champion
iTrader: (32)
this is where I get my springs from. Get the package springs rather than buy individually. I have bought duplicates of a couple just to run the same front and rear.
Moderators......wasnt sure if I could post the link I did. Just trying to answer a fellow racers question. If I’m punished for doing so I can accept it.
#1521
https://ultitires.com/
this is where I get my springs from. Get the package springs rather than buy individually. I have bought duplicates of a couple just to run the same front and rear.
Moderators......wasnt sure if I could post the link I did. Just trying to answer a fellow racers question. If I’m punished for doing so I can accept it.
but the springs i Buy are short or Long progressive for mtc1?
#1523
#1525
Thank you very much
#1526
Which spur gear can i use for my mtc1 mugen?
yokomo .....xray....Schumacher...etc
which are compatibile?
thanks
yokomo .....xray....Schumacher...etc
which are compatibile?
thanks
#1529
#1530
6Another question the new and option a2231 with blade are alluminum or steel?
can i use blade another chassis(xray....yokomo....etc)?
i can find blade delryn?
thanks
Last edited by tom1974; 06-03-2019 at 10:11 AM.