3mm offset with 190mm body
#1
3mm offset with 190mm body
I just purchased a set of HPI "Work SP1" wheels in a 3mm offset and I am running a 007 with the Mazda6 shell. Will this combination work or will it rub? If it will rub, then I wont bother with the look and get a zero offset wheel instead.
Is anyone running this combo (3mm offset with Mazda6 body)? Thanks.
Is anyone running this combo (3mm offset with Mazda6 body)? Thanks.
#2
Anyone??
#3
Front, back, or both? If you run 3mm in the rear, you should be fine. Running that offset in the front might be hard on the tires, and you'll end up scrubbing off speed.
#4
#5
You could get away with it, if you make the fender wells bigger. But it wouldn't look vary realistic.