igyrigged

iTrader: (1)

Yep, this is the track I was talking about in March. They still want to do an offroad track outside.

HPIFreak

and now im on standby ill be out at the chibana track around 10am or so today

YDBD

iTrader: (3)

had everything ready, couldn't make it, maybe next weekend...

igyrigged

iTrader: (1)

Crawling 1700 Toguchi tomorrow, Tuesday.

YDBD

iTrader: (3)

I forgot my rig and kit at home, I'll see if I can make it....

lulyoldjob

Ok, i found ya and now am all signed up, been looking and from what i can see the Axle Stubs are the same as the Axial Axle Stubs, i will order anyway just dont know how long they will take.

Good to meet ya Igy, hope to meet up again soon.

J

igyrigged

iTrader: (1)

Nice meeting you. It was unfortunate you only got to drive 2 feet before you broke. l have 2 stub axles you can have.

mr240

iTrader: (61)

Headed out to Chibana to run couple of packs. Been a long time since I ran my on road car.

mr240

iTrader: (61)

Had fun yesterday running my old onroad car. Need to change up my gearing for that track. Couple of locals who were at the picnic tables having a party came by and asked if they could run their cars also. Ended up doing a little mock race with the three of us with my two boys and couple of the local children as turn marshalls.

YDBD

iTrader: (3)

Sounds like fun! Got my cars ready, but just can't find the time to get there....

lulyoldjob

Stub axles turned up in the post today, not bad service in my book.
Now they are fitted i can see the very sight difference
between Axile and Berg the dog bong hole is deeper but with an o-ring we are ready to crawl again.
I'm going for 5" this time around if the weather holds.

Thanks again

igyrigged

iTrader: (1)

I'll be there a little after 5.

HPIFreak

ive been out to the chibana track a few times with my TT01. however, since i put in a brushless system, i cant seem to keep it from breaking spur gears its not that the gears are striping, its the pin that goes through the drive shaft that holds the spur gear onto it. it somehow moves and destroys the spur from the inside. ive gone through like 4 spur gears and a couple of the plastic "spur gear stopper" things. theres got to be a fix for this.

mr240

iTrader: (61)

Have you checked the TT01 thread in the Electric Onroad section here on RCTech. Should be able to find your answer there. If not post the question and someone who is familiar with the TT01 should help you.

raycerZ

iTrader: (2)

That is strange. I have been running a 16t BL in my TT-01 and have not had any problems (other than the back end breaking loose when I get on the throttle too soon).