MUGEN MRX4 LOLA SHELL PROBLEM
#1
MUGEN MRX4 LOLA SHELL PROBLEM
hi im having problems with my lola shell i had the same problem on my kyosho evolva in which only 1 shell fitted (collari r15) the front end is fine but the rear of the shell is quite high off the floor i have no idea why, the holes are mounted perfected there is nuffin obstructing the shell to sit lower and i cant adjust the rear floating body mount any lower...isit the shell? i havent tried the protoform p909 would that be any better ???????????????????
#2
With the shortest H-arms of the bodymount the entire cooling head of the engine should stick out above the body
#4
Why do you want it lower? The higher it is, the better it works.
If you just have to get it lower, make sure you have the short H arms on it.
If you just have to get it lower, make sure you have the short H arms on it.
#5
because at the moment the rear of the bodyshell is over a cm high off the ground i changed it to a shorter H arm that did make a difference but the rear of the lola shell is still quite high off the ground compared to over cars i see at my track and in pictures even when stationary so its not just the downforce pushing the shell down
#8
That is an obsolete body but should still fit just fine. My avatar is actually a Lola 530 on an MRX-4
#9
Next time dont cut the lower skirt too early. ( I usually leave few mm on the lower section ).
Cut ( and trim ) the lower skirt after you mount the body.
Cut ( and trim ) the lower skirt after you mount the body.