Tekin RS ESC sensored
02-23-2011, 08:35 PM
02-23-2011, 10:02 PM
02-23-2011, 10:32 PM
02-23-2011, 10:43 PM
Just got my shipping notification on the RS I sent in for repair! Amazing turn around time!
02-23-2011, 10:44 PM
02-23-2011, 11:07 PM
Or, you two could just come to Washington for the Carpet Nats next month.
I am sure we could find a "variety show" to attend...
Bill
I am sure we could find a "variety show" to attend...
Bill
02-23-2011, 11:25 PM
Wish I could...I have to wait for some money to come in to be able to afford the air fare 
02-23-2011, 11:28 PM
Tech Rookie
I overheard at Snowbirds that the N___K motor has an issue that if the rear bearing/retainer is either over tightened or something it can actually allow the rotor to short the sensor board out.you two could just come to Washington for the Carpet Nats next month.
02-24-2011, 09:30 AM
Does anyone know what the ESR rating of the capacitor supplied with the RS / RSPro? The leads on mine broke off, and I'm looking for a replacement....
02-24-2011, 09:51 AM
02-24-2011, 09:53 AM
Yes, I know that, but I asked what the ESR rating is - there are many 330uf 16v caps out there, but all with different ESR ratings. The only statement that has been made by Tekin is that the Cap must be a 'low esr' cap. I want to know what 'lows' mean.
The lowest ESR I can find in Canada is 9mOhm - is that low enough?
Randy?
The lowest ESR I can find in Canada is 9mOhm - is that low enough?
Randy?
02-24-2011, 10:07 AM
02-24-2011, 10:21 AM
Yes, I know that, but I asked what the ESR rating is - there are many 330uf 16v caps out there, but all with different ESR ratings. The only statement that has been made by Tekin is that the Cap must be a 'low esr' cap. I want to know what 'lows' mean.
The lowest ESR I can find in Canada is 9mOhm - is that low enough?
Randy?
The lowest ESR I can find in Canada is 9mOhm - is that low enough?
Randy?
02-24-2011, 10:22 AM
Back racing after a long layoff but the techology is making me crazy. You know how us old people are about new things? 
I suspected I could pull 70.0mm at Horsham but I have been running at Jim's and mid 60's seems fast enough for me.
I plan on running the motor at 0 deg to see if it makes a difference. I'm working on the assumption that no motor should make power with more than 60deg total timming?
I'll have to email you when we are going down to Horsham next time. There is life north of the belt way? Trying to get Chuck out also.
I'll have to email you when we are going down to Horsham next time. There is life north of the belt way? Trying to get Chuck out also.
02-24-2011, 10:33 AM
Reverse
how do you set this up so there's a delay between brake and reverse using 212 ?
how do you set this up so there's a delay between brake and reverse using 212 ?