INDI 16X7v6 = good charger?
10-06-2003, 02:35 PM
#1
INDI 16X7v6 = good charger?
I am looking for a new charger! I need one that can handle Nimh cells, at least 6amp linear charge rate, and one that can discharge at 30 amps. this one seems up to par, but at 200$, I was hoping I could get some recommendations of its competators? Maybe something a tad cheaper? thanks for any info any of you might have.
http://integy.automated-shops.com/cg...33103343716.79
http://integy.automated-shops.com/cg...33103343716.79
10-06-2003, 03:47 PM
#2
You're not going to find quality 6A charge and 30A discharge in anything cheaper. Evceryone I've asked likes the Integys (or the ones rebadged as Reedys). If I can't find a Turbo30 for what I can afford, a 16X7 is next on the list.
-dave
-dave
10-06-2003, 03:59 PM
#3
turbo30? url?
10-06-2003, 04:36 PM
#4
Turbo 30 is an old charger made by Competition Electronics. Thier newest charger is the Turbo 35 GFX, about $420 new. You can find old Turbo 35s and Turbo 30s for around $300 and under respectively.
For the price of $200 you cannot go wrong with a Integy 16x7 V6. This charger is absouletly awesome for the price. Not to mention it does not need a power supply.
Later,
For the price of $200 you cannot go wrong with a Integy 16x7 V6. This charger is absouletly awesome for the price. Not to mention it does not need a power supply.
Later,
10-06-2003, 04:38 PM
#5
Hello,
Visit www.speedtechrc.com for good prices on Integy chargers. Another good one is the Integy 16X9 v6 with the built-in power supply. You can always use the power supply later for an extra charger or lathe.
Visit www.speedtechrc.com for good prices on Integy chargers. Another good one is the Integy 16X9 v6 with the built-in power supply. You can always use the power supply later for an extra charger or lathe.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
