ESC forum
#407
Tech Master
iTrader: (15)
Originally posted by TFR
Do you mean a cap on the ESC??
Do you mean a cap on the ESC??
My standard (non-digital) servo bogged down the car exiting turns so I went to a digital servo.
#408
What kind of servo was it?
#410
it was a futaba S3003 servo ... it makes it easier to drive compared to hi speed servo cause my car is set up VERY VERY twichy.
and i m wondering if S3003 takes that much curent !!!!!! or is it my reciever ??? or ESC???
Plz help
and i m wondering if S3003 takes that much curent !!!!!! or is it my reciever ??? or ESC???
Plz help
#411
Regional Moderator
iTrader: (1)
the same problem happen to my brother's electronics....he uses 3pdf, cyclone tc, jeti receiver, and s9402...when ever the pulls the trigger, the servo twitchs really bad for a sec...then stables...and when he is about 50m away from the car, its like it gone out of radio range and act like crazy. its fine i use his remote on my GP...no twitch or glitch...its only his car!!
anyone know y?
anyone know y?
#412
Originally posted by Disaster999
the same problem happen to my brother's electronics....he uses 3pdf, cyclone tc, jeti receiver, and s9402...when ever the pulls the trigger, the servo twitchs really bad for a sec...then stables...and when he is about 50m away from the car, its like it gone out of radio range and act like crazy. its fine i use his remote on my GP...no twitch or glitch...its only his car!!
anyone know y?
the same problem happen to my brother's electronics....he uses 3pdf, cyclone tc, jeti receiver, and s9402...when ever the pulls the trigger, the servo twitchs really bad for a sec...then stables...and when he is about 50m away from the car, its like it gone out of radio range and act like crazy. its fine i use his remote on my GP...no twitch or glitch...its only his car!!
anyone know y?
#414
Tech Master
iTrader: (15)
Originally posted by Disaster999
really?? but the nitro uses the same receiver and nothings wrong wor!
really?? but the nitro uses the same receiver and nothings wrong wor!
#415
Tech Master
iTrader: (15)
Originally posted by imataquito
it was a futaba S3003 servo ... it makes it easier to drive compared to hi speed servo cause my car is set up VERY VERY twichy.
and i m wondering if S3003 takes that much curent !!!!!! or is it my reciever ??? or ESC???
Plz help
it was a futaba S3003 servo ... it makes it easier to drive compared to hi speed servo cause my car is set up VERY VERY twichy.
and i m wondering if S3003 takes that much curent !!!!!! or is it my reciever ??? or ESC???
Plz help
Try a small cap and see if it improves your situation. I soldered mine at the point where that ESC plugs into the RX. I slid the female pin plugs out a bit an attached the cap. My problems with lack of power exiting turns was solved.
Last edited by RCCadet; 11-22-2001 at 06:16 AM.
#416
Ty Rc cadet .. i will ttry that but can u plz tell me the rating for the cap
must it be the low ESR cap like the caps u use on the battry wires?
what is the rating? Volts and uF.
i m gona check my Rx to see if thers any small rocks in it hehe maybe one or 2 just got in there.
i lose lots of speed exiting the turns...... and the sad thing is i HAVE lost of grip for the turn and i can easilly shoot out of it taking a slightly tighter linewithout having to worry about my car losing control ....( car is setup to mildly overstear on trottle)
Thanl U again RcCadet
must it be the low ESR cap like the caps u use on the battry wires?
what is the rating? Volts and uF.
i m gona check my Rx to see if thers any small rocks in it hehe maybe one or 2 just got in there.
i lose lots of speed exiting the turns...... and the sad thing is i HAVE lost of grip for the turn and i can easilly shoot out of it taking a slightly tighter linewithout having to worry about my car losing control ....( car is setup to mildly overstear on trottle)
Thanl U again RcCadet
#417
anyone knows the answer to the question below ?
#418
Tech Regular
iTrader: (1)
MRT VX Pro ESC?
Does anybody have any info on MRT's new speed controller? In case you have not heard of it, it was tested and reported on in the December issue of the Radio Race Car International Magazine. The only problem it seems to be manufactured by a UK company, (MRT) and I can't find a distributer or hobby shop that sells it.
Please help! I'm looking to try one of these.
Please help! I'm looking to try one of these.
#420
Tech Rookie
Im just wondering what you guys think of a Tekin G12 ESC? I can get it for $50 Cdn. Think its worth it?