Serpent 966
#2176
i see.have you notice any diff with and without the front mount?how about the anti-scuat setting?what can it do for the rear end?
#2177
Tech Addict
iTrader: (2)
For those interested I have 2 TE V2 kits in stock left. 600USD plus S/H.
Cleaning warehouse I have alot of spares as well.
contact me at [email protected] for assistance.
Cleaning warehouse I have alot of spares as well.
contact me at [email protected] for assistance.
#2178
Tech Adept
Hi guys
What effect on handling should I get when I add shims to raise the rear upper wishbone? I have been running with 2.5mm but have not ever ventured into the effects of changing it.
Also, I am going to try the pfr18 body. I was going to mount at 20mm, is this ok?
Thanks!
What effect on handling should I get when I add shims to raise the rear upper wishbone? I have been running with 2.5mm but have not ever ventured into the effects of changing it.
Also, I am going to try the pfr18 body. I was going to mount at 20mm, is this ok?
Thanks!
#2179
Tech Champion
iTrader: (8)
Hi guys
What effect on handling should I get when I add shims to raise the rear upper wishbone? I have been running with 2.5mm but have not ever ventured into the effects of changing it.
Also, I am going to try the pfr18 body. I was going to mount at 20mm, is this ok?
Thanks!
What effect on handling should I get when I add shims to raise the rear upper wishbone? I have been running with 2.5mm but have not ever ventured into the effects of changing it.
Also, I am going to try the pfr18 body. I was going to mount at 20mm, is this ok?
Thanks!
#2180
Tech Fanatic
iTrader: (20)
#2181
Tech Adept
gday guys, wondering if anyone could help me, my last few outings i have been loosing my circlip to my middle pulley on the front oneway,its happened 3 times in a row,driving my nuts,its the 7mm circlip,this also makes me strip my front belt and pulley,im running out of spares.anyone else have this,or is it just me.
cheers burty
cheers burty
#2182
Tech Addict
iTrader: (2)
gday guys, wondering if anyone could help me, my last few outings i have been loosing my circlip to my middle pulley on the front oneway,its happened 3 times in a row,driving my nuts,its the 7mm circlip,this also makes me strip my front belt and pulley,im running out of spares.anyone else have this,or is it just me.
cheers burty
cheers burty
it can be because all is too tight fit...
#2183
Tech Adept
gday toughbeard,sorry bud ,should have been more specific,its the smaller inside pulley on the middle shaft. cheers for any help.
burty.
burty.
#2185
Tech Adept
sounds like a plan nitro,cheers bud,should have done it from the start,just another quick one,is it normal for the uprights to rub slightly on the inside of my rims,getting slight gouging on all 4 corners.setups as per default with a couple of changes to springs and oil.
cheers burty.
cheers burty.
#2187
Zero Force Serpent 966TE Bearing Kit Set
#2188
Tech Initiate
Does anyone know the difference 903351 and 903257 for 966? Upright 966 W2 vs Rear upright OS2?
#2189
The W2 gives more initial steering, it makes the car more "twitchier" and therefore harder to drive. Try both of them to see what fits your driving style, cause everyone's is different
#2190