E.J. Evans

Our original Photon had eccentric suspension mount inserts to fine tune roll centers. With the EX suspenions you can simply add or take out spacers to change the roll centers.

Better two weeks then two months! I've seen it happen more often then one would think. ;-)

skypilot

iTrader: (14)

Thanks EJ

Mr.A Morris

iTrader: (17)

LOTS of new goodies OUT

New Front caster blocks 4 deg and 6. With bigger openings. (Im assuming the new DJS will fit)

The new steering blocks

and new rear hubs!!!!

Most can be seen on

https://www.facebook.com/#!/pages/TO...95386490589769

others are on the EX group page!!!!

https://www.facebook.com/#!/groups/115953461872420/


Looks like I'll be putting in an order with OD here shortly! I'm not sure if these are released in the US yet. OD or EJ would have to chime in!

nnick

iTrader: (1)

Or here

Professor

iTrader: (12)

thanks mr a morris & nick. this is great news(no more xray parts on my photon)are these goodies available yet ???

B00t13g

iTrader: (9)

Does anyone have a good/ easy to drive setup for low to medium traction carpet?

Mr.A Morris

iTrader: (17)

The kit set up sounds like it would work pretty good. You can always check Hanulecs wiki page..


@ professor

Not sure. Usually by the time I see see them on tops Facebook page OD either just got them in or will have them in a few days.

Pilotloots

we tried that already remember? My Serpent kicked your T4's behind at coastal cup...

Professor

iTrader: (12)

thanks mr a morris

RC MARKET

iTrader: (12)

TOP released New Steering Block & Rear Hub Ver.2 ,
C-Hub 4 & 6 Deg Castor Ver.2,
Low Friction & Long Life Belt

Bishop

iTrader: (5)

New C hubs look good (I hate pulling them to remove or change drive shafts), as does the rest, does the third hole in the front hubs give more steering???

bkspeedo

iTrader: (5)

If you use the new third hole, farthest from bearing, it will create a shorter upper camber link which will give you more camber gain and make the rear of the car roll less which should loosen up the rear of the car.

hanulec

iTrader: (28)

I'll try to post my current setup. It was in only 0.25s off Larry this weekend -- and should be a bit easier to drive when grip is low. You need medium roll center arm mounts..

hanulec

iTrader: (28)

my current setup just posted -> http://racerlog.com/wiki/T.O.P._Photon_EX#Setups

for the upcoming weekend i'm planning on raising my roll centers 1.5mm all around to make my car more similar to Larry's

Motokas

Hello

IŽm Rui Almeida, Photon Ex Team Driver from Portugal

And can also see the news here - T.O.P. Racing Portugal (Facebook)

This is the new page I created for the pilots of Portugal and to all World drivers.

Hug to all

Rui dŽAlmeida