Losi XXX-S
#9632
Can i just say, Me + Aluminum front main pivot block + inner pivot= PAIN IN THE BUTT.
#9634
No, I got it. I was just had to tap it in place to finish it off.
the milling was easy, getting it on was hard, and i didnt want to break anything.
the milling was easy, getting it on was hard, and i didnt want to break anything.
#9635
Tech Fanatic
Tap???? What did you have to tap?
#9636
Originally posted by James Nguyen
Tap???? What did you have to tap?
Tap???? What did you have to tap?
But you should have seen John M win the stock B main at his hometown Newark track last Saturday. His improvement through the day was incredible. Next for him is getting into the A main. Then, I have to watch out for him...
#9638
Tech Fanatic
Originally posted by XXX-S Bill
Another beer keg? I hope!
But you should have seen John M win the stock B main at his hometown Newark track last Saturday. His improvement through the day was incredible. Next for him is getting into the A main. Then, I have to watch out for him...
Another beer keg? I hope!
But you should have seen John M win the stock B main at his hometown Newark track last Saturday. His improvement through the day was incredible. Next for him is getting into the A main. Then, I have to watch out for him...
#9640
Tech Fanatic
Originally posted by racenut123
Too bad you guys drive for the wrong team..........you would be faster!
Too bad you guys drive for the wrong team..........you would be faster!
#9641
Originally posted by racenut123
Yeah GaryO and I agree...John matrix is getting faster every raceday.Watch xxx-s bill, Nick.Hes got the car hooked!Too bad you guys drive for the wrong team..........you would be faster!
Yeah GaryO and I agree...John matrix is getting faster every raceday.Watch xxx-s bill, Nick.Hes got the car hooked!Too bad you guys drive for the wrong team..........you would be faster!
#9642
Tech Fanatic
I'd give him some this weekend but I'll be in socal.
#9644
Tech Fanatic
Originally posted by Randman
James, since you started running the trinity bearings, have they gotten gritty at all?
James, since you started running the trinity bearings, have they gotten gritty at all?