Bittydesign 1/10 TC 190mm bodyshells!
#737
💥 Our first ever body shell for the Front Wheel Drive class is finally unveiled, hello HC-F! 💥
The HC-F project was born from the desire to offer to all the rc enthusiast an new top quality body shell for the growing FWD divison. Tested for several months the product combine a stunning realistic aesthetic together with performance at the top of the class.
👉 The design recalls the forms of the "queen" of real scale front-wheel drive cars produced in Japan, the refinement phase took several months to optimize every detail, the attention to particulars has been obsessive in order to propose a body that could exalting the performance of the Japanese car at its best.
Check out all the amazing features and gallery at --> HC-F webpage
The HC-F project was born from the desire to offer to all the rc enthusiast an new top quality body shell for the growing FWD divison. Tested for several months the product combine a stunning realistic aesthetic together with performance at the top of the class.
👉 The design recalls the forms of the "queen" of real scale front-wheel drive cars produced in Japan, the refinement phase took several months to optimize every detail, the attention to particulars has been obsessive in order to propose a body that could exalting the performance of the Japanese car at its best.
Check out all the amazing features and gallery at --> HC-F webpage
#738
Tech Adept
Great!
Nice body, like it very much!
Will the decals be available seperately?
Regards
Michael
Will the decals be available seperately?
Regards
Michael
#739
#743
#745
Tech Adept
Are the window frame decals included? They look like decals on the finished bodies, but I don’t see them on the decal sheet.
#746
#747
Good body handling.
#748
Tried the fwd was great too.
#749
Tech Addict
iTrader: (22)
Question about the JP8 Pre-Cut for X-Ray T4 17/18. I bought one and mounted it up. Its a little forward on the front wheels as expected but its way forward on the rear and not even close. I can swap the JP8 between my T4/17 and my old TC6.2 I just had to elongate the rear body mounts about 4mm for the TC6.2. Both chassis' are good for the front wheel openings but both have the same huge gap in front of the rear wheel opening like the wheel openings are too close together. I have an M410 pre-cut that fit pretty good and I it was 2mm forward cut also so I'm not sure why the JP8 was so different. I posted the same on FB BD page but couldnt post pics there. Pardon the old wheels I use for setup.
#750
Super Moderator
iTrader: (239)
Question about the JP8 Pre-Cut for X-Ray T4 17/18. I bought one and mounted it up. Its a little forward on the front wheels as expected but its way forward on the rear and not even close. I can swap the JP8 between my T4/17 and my old TC6.2 I just had to elongate the rear body mounts about 4mm for the TC6.2. Both chassis' are good for the front wheel openings but both have the same huge gap in front of the rear wheel opening like the wheel openings are too close together. I have an M410 pre-cut that fit pretty good and I it was 2mm forward cut also so I'm not sure why the JP8 was so different. I posted the same on FB BD page but couldnt post pics there. Pardon the old wheels I use for setup.