ENGINE VENTILATION - Body cutting
#1
Tech Apprentice
Thread Starter
ENGINE VENTILATION - Body cutting
I have new bodies for my V-One and I'm wondering which is the best solution to balance engine ventilation and aerodinamic.
I used to make a hole on the front glass in the middle-high position and to remove the front/side glasses and completely remove the rear glass.
Some advise needed...
I used to make a hole on the front glass in the middle-high position and to remove the front/side glasses and completely remove the rear glass.
Some advise needed...
#2
This is correct. I think that you'll also remove front left and right glass.
#4
Tech Apprentice
Thread Starter
Thanks for your suggestions.
My doubt is mainly relevant to rear glass, if to remove it completely or to just open a hole similar to the front glass one.
I've heard different opinions on that...
My doubt is mainly relevant to rear glass, if to remove it completely or to just open a hole similar to the front glass one.
I've heard different opinions on that...