Tamiya Silvia Coppermix (Stop and Go)
#1
Tamiya Silvia Coppermix (Stop and Go)
i got my whole rc setup today and started playing with it but it just started going weird..when i go full throttle it goes and stops and keeps doing it...same for reverse.....and also its hard for me to get the r/c working cus the esc keep blinking and wont recognize my transmitter till i keep turning it on and off for some time....can you guys help me figure out whats wrong?!
#2
chekd the crystals the RX is all hookd up properly.....did u set up the ESC properly
#3
The only thing on those escs that will cause it to stop and go like that is the battery being dead. Trust me, I deal with TEU-101bk issues ALL DAY LONG. Make sure you followed the setup instructions step by step and check this link to make sure everything is right: http://www.tamiyausa.com/articles/fe...article-id=327
As far as recognizing the transmitter, that is not a esc issue, that is a receiver issue.
As far as recognizing the transmitter, that is not a esc issue, that is a receiver issue.
#4
okay i fixed the first problem but still have problems making it work with the radio?? should i change crystals on the radio and reciever to see if thats the problem?
#5
Tech Elite
iTrader: (1)
Join Date: Mar 2007
Location: Bristol, England, United Kingdom
Posts: 4,857
Trader Rating: 1 (100%+)
have you cut or pinched the receiver aerial at all? it wont work as well if its shorter than it should be. also, put new batteries in the transmitter.