Yokomo YZ-2
|
|||
#2491
Tech Champion
iTrader: (21)
I am going to try a TLR aluminum horn for the 22. It seems to have a similar off set tot the OEM Yokomo plastic horn. I had to drill and tap it for the 3mm ball stud however. I also ordered a 20mm Kyosho turnbuckle from AMain I plan to use between the ball cups. The manual says to screw the cups together but I don't like the angle of the servo like that, I like th servo to point straight up for straight ahead wheels. I plan to add 5mm of a gap with the new turnbuckle and the cups.
I don't want to sound harsh but I've seen many attempts in-person by people to "fix" the optics of a steering setup that just "doesn't look right" and haven't seen one yet that didn't leave them with a car that then doesn't even turn the same left and right.
#2492
#2494
Tech Champion
iTrader: (21)
#2495
Tech Master
iTrader: (15)
Update! The TLR aluminum horn did not work because it is too short, so full throw left to right was not possible. Threw the stock horn back on, using a slight 3mm gap, it all works nicely and nothing hits the bulkhead. Full throw both sides. The horn is still off centre but not as drastically as per the manual. I'd like to get an aluminum horn however, something in the 21-22mm centre to centre is needed.
#2496
What are some "must have" upgrades for the YZ-2 CA?
#2498
I have the weights already. just need to add VRP Pistons
#2499
#2500
#2501
Tech Rookie
For my yokomo i mont this optional:
Z2-300FLB5;Z2-008GFG;Z2-017G;Z2-107F;Z2-110;Z2-203A;Z2-412F + REAR BAR; Z2-413A; Z2-415GS; Z2-415RS; Z4-008RS4; Z2-670V; Z2-RW52 + 80G under battery;Z2-S2LD;Z2-S2SD;B4-011F;BM-S162; BM-S172; SD-008RC; YS-8BH; ZC-N4FLT; SPRING YATABE ARENA.
i should have put them all.
Z2-300FLB5;Z2-008GFG;Z2-017G;Z2-107F;Z2-110;Z2-203A;Z2-412F + REAR BAR; Z2-413A; Z2-415GS; Z2-415RS; Z4-008RS4; Z2-670V; Z2-RW52 + 80G under battery;Z2-S2LD;Z2-S2SD;B4-011F;BM-S162; BM-S172; SD-008RC; YS-8BH; ZC-N4FLT; SPRING YATABE ARENA.
i should have put them all.
#2503
#2504
Tech Initiate
Arms, ballcups and front bulkhead.
#2505