3 racing new F1
#3797
Tech Adept
Well I took the plunge and ordered an FGX and a ton of hop-ups. Can't wait.
#3798
Is the chassi upgrade to carbon a must on the FGX or the original company plus IFS is ok
Which are the best online shops for F1 accessories for FGX?
Thanks.
Which are the best online shops for F1 accessories for FGX?
Thanks.
#3801
Tech Apprentice
I agree with you, the whole block shall be made of alloy. I guess that 3racing may make this an option part soon.
#3805
Yes I did and i found it AWESOME to drive, tested and raced the EGX IFS at the same time,and I was surprised in the difference it made.
I had a hard hit at the front end and cracked the nose top deck, in this mishap I found that putting the 3 racing longer std ballstuds in gave it a bit more strenght in that area as my hit at the front ripped the ballstud out, so may even go longer with nut ( not lock nut as it is to chunky ) and spring washer, we'll see.
I haven't at this stage played with set ups but where it is now is good, just finer adjustments here and there, hopefully i dont need to change much of the set up that i end up with on the EXOTEC IFS.
Some photos at race day, no action shots unfortunatly, Body was just a test with doing a cardon fibre wrap.
I had a hard hit at the front end and cracked the nose top deck, in this mishap I found that putting the 3 racing longer std ballstuds in gave it a bit more strenght in that area as my hit at the front ripped the ballstud out, so may even go longer with nut ( not lock nut as it is to chunky ) and spring washer, we'll see.
I haven't at this stage played with set ups but where it is now is good, just finer adjustments here and there, hopefully i dont need to change much of the set up that i end up with on the EXOTEC IFS.
Some photos at race day, no action shots unfortunatly, Body was just a test with doing a cardon fibre wrap.
#3807
Yes but If I glue the whole thing together I loose the option to change the camber settings, and I need this until I find the correct IFS settings for my FGX.
I agree with you, the whole block shall be made of alloy. I guess that 3racing may make this an option part soon.
I agree with you, the whole block shall be made of alloy. I guess that 3racing may make this an option part soon.
Just some ideas for thought
#3808
Tech Master
iTrader: (41)
I guess that's what I ended up with. I can still adjust the camber with the exotek upper arms.
I had to polish the aluminum ball hinge with sand paper a lot to make the exotek upper arms work smoothly with the IFS. Now I actually have 1.0 ~ 1.5 mm droop at the front.
I had to polish the aluminum ball hinge with sand paper a lot to make the exotek upper arms work smoothly with the IFS. Now I actually have 1.0 ~ 1.5 mm droop at the front.
Last edited by edhchoe; 12-01-2012 at 03:01 PM.
#3809
It is time for me to get a carbon fiber chassis, any opinions on which one is the best?
#3810
Tech Adept