I hope they come out with there own rear hex wheels so i'm not forced to use the substandard 22 wheels.

Yeah i know what you mean.

Nope. At least not anymore than it would bother me that some people are selling their 22's to drive a B4 again just because one won an event in Finland!

+1....too funny.....

I would imagine Jconcepts releasing some aluminum hexes for the conversion. They said they had quite a few new items releasing during this race.

22t is 10mm longer

Sounds like a good time to try a SC10 chassis conversion.....lol...

I think that was from bumper to bumper.

10T4.1 wheelbase = 288mm (11.34in)
22T wheelbase = (286-290mm) 11.3-11.41 in
XXX-SCT Wheelbase = 12.99 in (330mm)

It appears the new hex front wheels have a "glue groove" around the edge to capture the CA. nice feature.

YES HYES WHOOO. i JUST have to wear out all these tires I have and chuck the rims lololol. I will change the fronts before the rears, damn those stupid bearings

@ash- lmfao well your the one who drives 3 different ones! lol

I don't think they're falling behind, and I hope they succeed in bringing it back because I tire of these silly short course trucks. I'm going to end up running buggy because stadium truck is effectively dead at the club level, even though I'm told ST is better when you're learning.

I hope these hex's don't make the rear wheels cause axles to break like the kyosho's and the 22's do.

I see that you can use Kyosho front wheels with that...

I have a few 2wd fronts left sitting around here.

I see AE is releasing their own front wheels but i see no mention of rear wheels? Does that mean you would have to run Losi wheels

Also correct me if i am wrong but the B4 and SC10 share the same front axle so those axles are already available by Proline