Any news on any new ESC coming out?

Anyone got a tip about starting higher or lower on the FDR for the new MMM 10.5 motor compared to the 10.5 1Cell? Was running 7.05 on the V3 1 cell with 110323 stock, but the same settings did feel slower on the MMM.

Anyone know the program number for the "blinky" program. And where to get it... I think I've got it, but I cant see it blink...

Thanx in advance, Kevin

Received my 13.5 MMM motor today... What should i be looking to gear around on a 20x14 circuit using Hobbywing xtreme.

Cheers

XRAY2011, not to single you out as recently I have seen many requests for FDR/ESC settings. Here is a re-post from 2 years ago as to what information is needed to help us help you.

1. Boosted or SPEC ESC and what firmware you are running.
2. Your current Speedpassion ESC settings
2. Your motor brand & physical timing
3. Your current FDR
4. Your track conditions: Tight or open, how long the straight is, etc..

And also dont forget that www.speedpassion.net has a section dedicated to ESC setups for all forms of racing.

Jimmy

It is under testing phase now...I don't see anything solid until November/December time.

Remember....MMM run on a 20* timing ring...1S V3 runs on a 10* timing ring...if you are gearing 7.05 on 1S with 10*...you cannot gear 7.05 on MMM with 20* and expect it is faster, infact, I am sure you are over gearing it already.

Try 7.5 final with 15* timing on can...I have yet to run 10.5 MMM and this is just my wild guess....

I WANNA TEST!!! LOL

I remember when we had the 1st gen of the BOOST stock software...I blew up (4) 13.5 motors within 3 hours (until I ran out of 13.5 motors, then I go to the 17.5...3 more blew up within another 2 hours)...1 motor per round, less then 3 minutes each. How many motors you can provide and how many DNF you can afford?

Do you remember how much that cost me?

Thats why we don't want to review those here...we only share good news, not bad news.

well i got a few i could put up in smoke.. would be testing those too LOL

I was wondering if anyone has a problem with a KO PROPO 10 binding with a cirtix club esc.I used the cirtix with a M8 with no problem,changed radios and can't get it to bind.I go through the set up in the book and on SP internet and the lights do what there ssupposed to do but then the red light starts blinking.I've tried I don't know how many timesto reset both of my esc with no luck.If any body has a idea post it please.

reverse the throttle channal on your radio that should work

can i update the speed passion GT v1.1 firmware?