yeah from that shot it looks alot worse then it really is lol, i want to shorten up the novak wires to clean it up, but i just "coiled" them

and shorten up the battery wires for bullets, still deans from my promatch packs.

I'm officially a AE fanboi, just bought a sc10 4x4..its gonna be a long nite..

Congrats.. If you haven't already, check out the first page here: http://www.rctech.net/forum/electric...x4-thread.html

There are some must see build tips...

Thanks!! Yea, already found out my S6040 servo wire is not long enough..
Gonna go with 10K diff oil up front.. so much to read/learn.

Still got so much to improve/learn on the b4.1, its going to be a busy summer..

I dyed my springs with Rit too the other night.. The yellows came out a little army greenish, but they look pretty clean.

I like the RIT dye method....keep it stealthy, keep them guessing.

Congratulations to AE on their 25th world championship!

yeah the blue didnt dye really well at first (you can see in previous photo), but just toss it in longer (reboil then put it back in) and now it looks factory black

Yeah, I might need to do another round. The front oranges turned out really good though.

same on mine, i thought they where gunna be a pain, but cobalt ended up being a pita hah.

That is hilarious!

Hey i have the factory team b4.1 and it is already built but just picked up a lrp x12 13.5,align ds 620 servo,gens ace 40c hardcase,and will most likely pick up another rs speedo but really want to know what type of gearing i should run. I have alot of different pinions and a few spurs but want it to be as cool as possible but want it to be the most efficient i could get it.I also want to know if you guys are using weights,if so where.any info would be nice.this is the track ill be running on.

+ YouTube Video

I have no experience with carpet tracks but I run 75/30 w/ a 13.5 motor, no timing/boost. I run the Lipo Ballast weight, 1/4 oz in each rear side pod, 1/2 oz next to receiver, and 1/4 oz on each side of the servo compartment (mounted sideways on the outside lip of the chassis next to the servo).

how does it fly in the air?compared to stock setup?