I will let you know when I test the pipe this weekend. I know my drivers that attended the Euro's a couple of weeks ago told me that the 2668 was the pipe to have. Most of the RB engines were running it. I was told it made gobs of power, and decent runtime.

Thanks, let me know!

RB .12 mod What would be the different in gearing for this motor coming from a nova flash .12???

Thanks

Same gearing should be fine.

I just came back from the 34th Annual Texas Biggie. I participated in the 1/8 GT class. My engine of choice was Murnan modded Novarossi 35 plus 21. All I can say is WOW!!!!!!! What a beast. The engine screams at low end and top end. I was able to TQ'ed after 6 qualifiers. Although my car was not able to finish the race due to an unfortunate push into the wall by other cars and broke in the 45 min. A-Main, however first ten minutes into the race I was already 2 laps ahead of 2nd position driver. Thank you Uriah for a superb modded job and a wonderful engine.

Hi Uriah!
On My last race the rbm3's rod 's broken.so please give me advice,
The engine is 1 year old it has 8 race, the problem is not just the rod, the bottom of the piston broke, the bottom of slave pushed. As i saw the crankshaft is fine but the crankshaft pin has a little bit different dimension already.
I can measure .02 mm different from other direction, so is it right or out of tolerance? The bearings are fine yet , so is it enough to buy a new pis/sla/rod set or a complete new engine .

Thaks!
Chrys

Murnan Picco Torque

hello i have been trying to contact mr murman.. i sent some emails through the site and i just sent one to an yahoo email... please contact me [email protected] im interstedin some motors

Hi. Usually if the rod breaks the engine block is damaged. If the block, and crankshaft are ok then you can rebuild it. That crankshaft pin is within tolerance.

You can send the engine to me for inspection to be certain that everything is ok. Sometimes when that happens the crankshaft can get slightly bent.

I sent a reply. Please check your spam filter. You can call me to discuss if you prefer. 770-378-9669

Murnan 21-35 Motor takes win at Round 2 of the Midwest Series.
Portage Indiana.
Motor setup
24 Head clearance.
8mm Venturi
Max 6 Plug
16% VP fuel
Total time on motor 2.5 gallons

Vector03Cobra (Jeff Zuccarell) Below First Place (Black Car)


Gota Thank the Pit man Marvin Davis

hey guys not only is murman the man when it comes to moding.. but hes great with service also.. i call and order on wed and had me a fresh built mot on my door by fri for my race..... thank yyou very much i look forward to winning and promoting u very much

uriah, Is the P/s set for the RB T10 and T10 rc the same. Have a RBT10 Rc but your site list just RB T10 set. Thanks. Also what plug recommendation for this motor for hot humid weather in the south.

The P/S sets are not the same. The RC has more exhaust timing. The standard t10 P/S set will work just fine in the RC though.

For hot, humid weather use either the c7tgf, or the c6tgf nova plug.

Uriah, which one of your modified P/S sets would you recommend for my RB10 RC?
Some novarossi sets work also, right?