It's possible. You would have to check to be sure. I'm running a Mugen flywheel right now on my Xray buggy with a full Xray clutch on it.

i would check ebay and find someone parting out the new TLR truggy kit. im sure it will have the updated axles since the kit was just released recently.

No Mugen's wont work, I would like to suggest you try new arms as well, A Bowed or Overly stretched arm will allow the bone to sit on the edge.

Yes clutch's are somewhat interchangeable, But drive shafts aren't.

I have tried switch the R-arm to Left side but it still the same....

Looking to replace my 8T 2.0 with a new one. Anyone know who has them on sale right now?

Send Greg B on here a PM, he had them cheap.

$469.99 for the Race-Roller. Just got a few more in stock.

I can't see them on website.

Hi guys, I know it has probably been posted somewhere before but what are the settings when installing the V2 tower and what else needs to be done?

Thanks

Hi Bopracer, go to the TLR web site and there are setups there including Adam Drakes V2 tower standard setup.
Cheers
Scott

I picked up some of the Inclined 12 degree spindles (LOSA1733) for my 8T 2.0 but I am not sure what I need to do with the turnbuckle setup to get them to work. Is there a video or something in how to re-setup your turn buckles once these are installed?

Thanks

Nothing at all just make sure you use the little spacer in the hole that's not used. It sticks out and looks a little funny but it's necessary. Then re measure/ adjust camber and go run.

Nothing at all.... Huh... And the will work on a RTR kit? Maybe I installed them wrong.

What's the problem?