anyone know where to get this setup sheet from i went on the website thats at the bottom of the image but can't find it.

cheers for anyone that helps

chk first post of this topic.

cheers mate should of looked at the start, thanks again

i've just noticed on the setup sheet thats there is a 213 software i can only find 211 anyone know where this is, its not on the hobbywing site

213 isnt out yet only a few people have it ...

Hello fellow hobbywingers.
I am a longtime user of HW products but this is a new project for me and I need some help.
I am installing an 8.5t motor into a 1/10 ep buggy with an HW speedo.
Can anybody give me a pointer as to the best software profile to run and maybe some ball park settings.
Thanks chaps.

I've even disabled it. Thing is, it doesn't happen with another 60A esc.
I've reflashed the esc several times.

Hi Guys, just sharing what I've been working on today;

Associated TC6
LRP X12 10.5 (Massive Heatsink and Fan)
Extreme Stock w/211 firmware
Sorex 32 (knackered)
Orca 6000mah 60C
LTC-R

Track - Halifax, UK (Massive, High Speed with great traction)
Track Temp - 43*c
Air Temp - 22*c

Ratio - 6.96

3
37
12
19
13000
0.4
550

Great punch throughout the track, noticable even with it being a revvy track. Top speed excellent, same speed as a guy preparing his 1/10th IC car for the BRCA Nationals!

Motor came off at 90*C. Would be alot hotter without the fan.

Bit pink now from the sun and need a beer

Ran 17.5 class today. Track was low grip due to water weeping up from the cracks in the asphalt. But the Type R was very good. I was the only one to turn 20 laps, & that is including the modified class also.
Here are my settongs:

MOTOR: NOVAK SS 17.5
FDR: 7.81
F/W: 211
MOTOR TEMPS: 119
ESC TEMPS: 85
RUNNING MODE: FORWARD/BRAKE/REVERSE
DRAG BRAKE: 0%
VOLTAGE PROTECT: CUSTOM 6.2
DDRS: LEVEL 9
BRAKE FORCE: 87.5%
REVERSE FORCE: 50%
INITIAL BRAKE: 0%
NEUTRAL RANGE: 6%
BOOST TIMING: 35
TURBO SLOPE: 18 UNITS/0.1 SEC
OVERHEAT PROTECT: ON
TURBO TIMING: 30
BOOST START RPM: 4000 RPM
TURBO DELAY: 0.3 SEC
TIMING ACC/SLOPE: 350 RPM/UNIT

anyone has a base setup for 4.5t motors with 211 software?

Try Tryhard´s setup a couple of pages back. I used it today on a very large track with a SP 4.5t. Good power, low motor temps (60C) Air: 20C.

Anyone got any setups for 1224? Thanks.

Does anyone know if the extreme stock with fw211 can be programmed just on The speedo as I have lost my 2 in 1 box. The manual says it can but wasn't sure if the new functions on thus fw would be ok to do on the button only ?

the instructions say it can only be done via the lcd box.......... cherry will be at the stcc next week and i shall be at the btcc at wlrc, i have a brand new one also 3 brand new 13.5 motors

i have tried with a x12 octa wind, 13mm rotor. loads of power, but motor temp is high bit at 90deg.

Which parts shld i tame it down?