2.4 Conversions
03-15-2011 | 07:43 PM
#16
also beleaguered why it behaved that way, hehehe...
but happy it worked. now its off to my EX-5. 
but happy it worked. now its off to my EX-5. Thanks to your PM telling me where you tapped the power from, I got it to work. I had no idea that the PC board would not have enough juice to make it perform correctly. I ran new lines from the battery and off the switch and it fired up and bound to the receiver. I am stoked.
I also prayed to find a way to make it work. Tempted to write it off as luck, but its eating at me. Thank you for your help Slow_Jun.
I also prayed to find a way to make it work. Tempted to write it off as luck, but its eating at me. Thank you for your help Slow_Jun.
for our brothers in Japan.
.
03-16-2011 | 07:56 AM
#19
03-16-2011 | 05:44 PM
#20
I manage to test it on my EX- 5 and the response was pretty fast as compared from my AM, 
im a bit happy, sad to say that i have a slight servo jutter (from left to right) but its tolerable, dont know if that will effect when your running high speed,. Last night i tried running it and it can go straight with out any swaying left to right. need to check if it will cause problems on tracks.
im a bit happy, sad to say that i have a slight servo jutter (from left to right) but its tolerable, dont know if that will effect when your running high speed,. Last night i tried running it and it can go straight with out any swaying left to right. need to check if it will cause problems on tracks.
03-17-2011 | 07:09 AM
#21
I am a little concerned about the jitter. I dont really think that it will keep me from doing anything that I need to with the radio, but you are right in that it could be annoying. Especially with the Savox.
03-20-2011 | 01:31 AM
#26
Nah, did not work, do you have an extra anthena for the tx?van you try to replace it with another 2.4ghz ant?, dont have one and i notice f. Touch the anthena,thr jitter goes away and if i remve the anthena, its ok.
Dont have one so no way for me to test.
Dont have one so no way for me to test.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
