Hi all,
Figured out a way to get the steering pot to come good again.
All it needed was a little pressure on it. So I basically took the wheel off and the cover, put a couple of shims on top of the bearing, put it all back together again. FIXED!

Nevermind! I did a little digging around the Futaba website, the double transmitter case is actually deceptively small. So I went with the official Futaba 3PK case. Very nice! And with some carefull cutting of the foam innards, you can fit quite a few extra items....

Just thought I'd post a few pics, incase anyone else is interested in using a 3PK case as pit box!





No space for my fuel though. Heh heh!

IS there a way t oset the 3pk back to default settings? Default meaning the settings one the radio when u take it out of the box?

I think you have to perform "model reset" to each model memory. Not exactly what you want to do but it should center all trims and default to out of the box state.

I have a 3pk with spectrum sm1001 2.4gz module and have broken the antenna. Does anyone know where I can get a replacement antenna?

Thanks

hi guys.ilost the frewuency chart that is coming with the 3pks.can someone scan it for me?i want to know the frequencies at 40 mhz ih hk.
thank you in advice!

When I turn on my 3PK, no beep and buttons are locked except the trim & function dial wheels. All other buttons are locked. Transmit indicator = "RF".

Any ideas on what's going on?

Thx

small switch on the side of the radio....Its a Display mode where you can turn on the radio but not broadcast a Signal. So if your in the pits and need to check something on the radio or make a minor adjustment you can without fear of effecting some one else channel.(2.4Ghz essentially eliminated this)

Thanks. The "Display" switch doesn't appear to be doing anything. Same radio behaviour irrespective of switch position.

Interesting....Have you tried contacting Futaba at all ?

or u have both display switch & power on. try off the main switch... then switch on display... the lcd should lid showing the display. where u can adjust the trims... in a working condition.

hey guys what would be the best reciever to get for my second car, the stock kit reciever or maybe something alittle cheaper than 90$$
normal kit, no spektrum module.
thanks

No other companies rcvrs will work. I've had good results buying these used and saving a lot of money.

You've got some options if you want to go with HobbyKing knockoff, but I stay with the real Futaba stuff.

Guy's just starting to run a lipo RX pack,and was wondering how to keep the rx pck from droping below a safe voltage? Im runing a 3pk super,R614FF and R603FF rx's. Would be nice if the TX would Beep or vibrate at a sertane voltage.. Thanks in advance

I have searched this thread and others have asked the same question, but I haven't seen anyone answer. I saw a 3pk with a dropdown and an angle wheel mount and I want to know where I can get the angle mount?
Thanks for any help.