im not running high voltage servos and i run lipo straight and i run yeah racing lipos which are smaller and lighter then the losi lipos

What servos are you using?

you guys will probetly think this is funny well i got the 2.0 outer rear hinge pins and i had to use the 2.0 rear hubs also well it was getting late and i had to get done my truggy. and i was thinking that on the hub i was assuming that, the 3 hole on the rear hub was the a hole well it was the b hole well i went to race yeterday and kept on wondering why in the hell i cant get my rear to rotate right without useing the brakes lol.


so on the 2.0 rear hub is it ok to use the a hole on the hub with the #4 on the rear shock tower ? i just mounted it in the a hole on the rear hub with the #4 on the tower i just need to adjust the camber again .


or should i run a diffrent postion on the tower holes ?

Hitec 7955, so is my dad

Hitec servos aren't the prettiest on the block but they are the most reliable.

i've been running 7955 unregulated for awhile now with no issues.

I ran the Losi Lipo when they just came out, and I only had problems with them, after some research, came to the conclusion it was probably the internal board they had, since then I switched to the dynamite pack and been running it thru the last year with no problems, but it's time to refresh it, because of the tight fit the external packaging has wore out. Maybe I'll give Losi another try, a fellow racer mentioned that board issue was resolved a long time ago........

I love my 5$ packs.

Got a link mister?

Found a couple good deals for 3X and 4X

4X
http://cgi.ebay.com/4x7-4v-900mah-15...item3f03315791


3X
http://cgi.ebay.com/3x7-4v-900mah-15...item4152e1560f

After running a commonsense 1700 lipo for a year I broke down and bought the $50.00 2000mah Losi pack. The first time I charged it, it would go to trickle mode at like 8.10 volts. So I went ahead and ran it,as I was at a big race and had no choice. Next charge was on my buddy's hyperion and it said "check battery". I bought a new higher end charger instead of my SB 989 and it would not charge either.Display say's "battery disconnect". So I have a faulty battery. Those 5$ ebay specials are looking good after this.

I love my 900's.....you wont catch me with a 100g losi in my rigs.

So you can run 30 + min mains with these 900's with no issues?

and these fit with no mods or anything???

i run the 800mah hobbyking batteries. after 2 5min qualifiers it only uses 225mah. i have run 25mins with no prob. so i would say that 900mah will b fine for 30min