oh ok , then you should be fine

Hi guys
Just wondering, Is the SP GT2.1 Prostock ESc capable of running Mod motors?
What is the limit? And need to change software/firmware? Thinking of purchasing one. Already have the GT2.1 Pro, Making that as spare.

Thnks

dam drunks

I dont have one yet but If i recall its a 9.5 motor limit

120x60

thank you mr crum,are going to have any thing for me this weekend

Unfortunately, there is a Bug in FW 100422 DDRS, (not present in 100324) can be solved?

doubt it since we dont run the same class

wat bug?

Supercharger does not work if you set a value less than 7 in DDRS.

DDRS we leave it at 8 or 9. Reason being, with the Supercharger software, we now control punch with SC Punch #15. If you want more punch, lower your parameter on #15. All these settings relate to each other. If you turn down DDRS too low, SC Punch will not be activated.

Marcos, what kinda of esc temps were you getting on that setup? I temped at 108. and 116 on the motor. I see the cutoff is 90deg?

My esc was 92 degrees and motor was 112 that was outdoors in florida

Ok thanks Charlie, then with the Supercharger DDRS is disabled.

Not quit sure if it is disabled, it just needs a higher setting for it to work with the system.