KO Propo EX-10 EURUS
#1711



Pass you soon...
#1712
Had a search but not found anything,
Had an issue with my Eurus today, where the throttle lever is very sticky. As in it can get jammed at full throttle or brake, and has a very 'jammy' feel and not smooth. Thankfully it happened at the end of my run so didn't matter too much, but can't really drive with it as it is.
I was wondering if anyone has had a similar issue and if there is anything that is an obvious replace to fix this? It is 4 years old, so has had a lot of dirt/dust in it I would imagine, so going to open it up and check it out.
Cheers
Scott
Had an issue with my Eurus today, where the throttle lever is very sticky. As in it can get jammed at full throttle or brake, and has a very 'jammy' feel and not smooth. Thankfully it happened at the end of my run so didn't matter too much, but can't really drive with it as it is.
I was wondering if anyone has had a similar issue and if there is anything that is an obvious replace to fix this? It is 4 years old, so has had a lot of dirt/dust in it I would imagine, so going to open it up and check it out.
Cheers
Scott
#1715
I still think the Eurus is still a top radio but since KO killed it, it's hard to find receivers for it. Mine has the 902 module if I replace it with a 904 and 3 receivers it almost cost as much as a KIY.
#1716
Tech Initiate
Joined: Oct 2008
Posts: 29
Thanks!, I have the opportunity of buying one eurus with 904 module and KR-413 receiver or a KO KIY for about the same price both used.
Phisically I prefer the eurus, but in terms of performance I am not sure.....
Phisically I prefer the eurus, but in terms of performance I am not sure.....
Last edited by Raulote; 05-23-2015 at 03:33 PM.
#1717
Tech Apprentice
Joined: Apr 2010
Posts: 75
Hi guys i have an issue with 1 receiver on my radio , a 407s , it seems don't want to bind on the radio ...
Folloow steps to bind it , and when i turn on the receiver while keep (setup button ) led turn off then turn on , and when i realease button led return off ...
My receiver is dead you think ??????
Folloow steps to bind it , and when i turn on the receiver while keep (setup button ) led turn off then turn on , and when i realease button led return off ...
My receiver is dead you think ??????
#1719
Tech Apprentice
Joined: Apr 2010
Posts: 75
I have test with another receiver and everything is ok ... so I think my 407 is dead...




