Luckily we got the awsome lights to run under at night. And besides is that not what autosol is for and a bit of elbow grease. That was a big help from you and at this early stage does not seem to be to the detriment of the motor. But gee whiz it gets them run in quick so at only 4 hours per engine plus running time thats about 5 hours per engine. Plenty of time haha.

hey guys where you getting the new xxxv from? kellets?

Hey mate I get my Sirios off Jeff at Tracksiderc in Brisbane, How ever I'm pretty sure he gets them from Kellets as they are the importer. I pick up my 2nd V this arvo, I think there readily available.
Noel

Yeah Kellets hobbies in Syd. Trackside in Brisbane also had some in stock when I was there a couple of weeks ago.

anyone know the factory carb settings for sirio evo 4 sti?! i replaced all my o rings on the needles (4 needles) and now need to know where to start off with the re-tune process!!?

http://www.youtube.com/watch?v=yjQlz3b3VC8

Open them a full turn more than what you see on the video. Except that gold one. Dont touch the gold needle.

does anyone know how to adjust the sprat bar needle?

I use a flat blade screwdriver. The same one to adjust all the needles.

Looking to replace the rear and front bearings on my Sirio XXX.... Does anyone knows the dimensions of the bearings for this engine?

these sirio .12 XXXV engines are they good, i have the aged old sirio evo4 sti engine! should i upgrade for this new XXXV?! or is it a up-grade let me know guys!

noticeably better, good as you get

As above

Anyone??

same as the evo 4 front 7 x 18 x 5 and rear 12 x 22 x 5 hope that helps

Thanks for your help!!!