Radio Control Hobbies & Raceway - Waterbury, CT. - Page 163

12-13-2008 | 10:35 PM

#2431

tschenck

Tech Elite

iTrader: (110)

Joined: Oct 2007

Posts: 2,729

From: Willow Spring NC

Quote:

Originally Posted by tecniquin2001

In the old layout fastest laps were low 16s, high 15s with 22 laps in qualifiers and 29 laps in mains.

New layout, low 19s, high 18s, with 18 qualifier laps with the truck and buggy, and finished with 24 laps with the XXXcr and Mark finished with 27 laps with the 2wd.

I don't really know how the 4wd guys were doing as far as times and laps.

Everyone starts in the front straight away, then a pipe is laid down after everyone takes off, you go around the big sweeper, over the table top, like before.

I was wondering how everyone was going to fit on what was left of the straight. Anyways since your truck times are close to my buggy times it looks like I will be adding about 3 seconds a lap. Looking at it this morning I was figuring I would be around the 19 second range. Looking forward to trying it out on wednesday. Probably will put back in the 10.5 too.

12-13-2008 | 11:07 PM

#2432

tecniquin2001

Tech Elite

iTrader: (13)

Joined: Sep 2008

Posts: 2,941

From: Connecticut

I drew a picture of the new layout on MS paint.

The scale might be off a tad, but you get the Idea, GET OFF MY CASE!!!!

Attached Thumbnails

Radio Control Hobbies & Raceway - Waterbury, CT.-rchr-layout.jpg

12-13-2008 | 11:12 PM

#2433

tecniquin2001

Tech Elite

iTrader: (13)

Joined: Sep 2008

Posts: 2,941

From: Connecticut

On my second Qual. I forgot to turn right after the second sweeper and shot down the straight and went over the 1" pvc barrier.

I was in 2nd place and dropped to 4th for that douhhh mistake

DON't Forget to turn guys

12-14-2008 | 02:38 AM

#2434

newera152

Tech Master

iTrader: (4)

Joined: Jan 2005

Posts: 1,031

From: Conn

paint work

Whats up guys, any looking for trucks or buggys bodies done, I can paint for you, can post pic,
Thanks era1FX

12-14-2008 | 04:53 AM

#2435

hdmm

Tech Regular

iTrader: (6)

Joined: Dec 2008

Posts: 303

From: Florida

Quote:

Originally Posted by tecniquin2001

Were you at the track on Saturday??

I know there were two new guys, that I haven't seen before running 4wd, were you one of them??

Yeah I was at the track Saturday, just watching though. Maybe I'll race next week or so. I have to chanceg the motor in my B44. I'm running a Velocity 6.5R , I don't think I can gear it down enough for that track.

What might be a good KV motor to run in a 4wd buggy at the track? It's alot smaller than I'm used to so I have to kinda start all over!

Last edited by hdmm; 12-14-2008 at 05:41 AM.

12-14-2008 | 05:30 AM

#2436

BlueB44

Tech Adept

iTrader: (1)

Joined: Aug 2008

Posts: 155

From: Plainville, CT

Thank's Freddy! that's a good pic.

very smart RCHR. didn't have to move a lot of dirt yet you have completly made a new layout. I'm excited to try it!

Jason

Last edited by BlueB44; 12-14-2008 at 06:42 AM.

12-14-2008 | 06:40 AM

#2437

tecniquin2001

Tech Elite

iTrader: (13)

Joined: Sep 2008

Posts: 2,941

From: Connecticut

Hey HDMN,

You can alway turn down the EPA on your radio, I run a 5.5 velociti on my truck and turned the EPA down to 70%.

You can turn the EPA down on the 6.5.

Just an Idea if you have EPA adjustment.