PPD TC setup plates. TC5, Mi3, Xray, Cyclone and ??
#19
Thank you everyone for the suggestions and "votes" on next plate...right now looks like Cyclone is front runner adding posts here and PM's.
First 5 TC5 plates ordered all went out this afternoon!!
Dont forget to drop back and share your opinions / results!
*** PLEASE NOTE ON INSTRUCTIONS***
I found an error on the hex driver on required tools. Its a 3mm ball or std driver you'll need and a 4mm screw. The error says 4mm ball driver, that is fixed now.
First 5 TC5 plates ordered all went out this afternoon!!
Dont forget to drop back and share your opinions / results!
*** PLEASE NOTE ON INSTRUCTIONS***
I found an error on the hex driver on required tools. Its a 3mm ball or std driver you'll need and a 4mm screw. The error says 4mm ball driver, that is fixed now.
Last edited by Verndog; 08-31-2009 at 11:51 AM.
#20
Hello Verndog, I am getting one of the first 5 to go out. Look forward to trying it out. Will let everyone know how it works for us. Thanks Ron H,
#22
#27
Very interesting tool! an very beautiful!
I would be certainly interested in a Cyclone TC model... But I'm not sure that all the cyclone have the same chassis plate...
I would be certainly interested in a Cyclone TC model... But I'm not sure that all the cyclone have the same chassis plate...
#28
I'm in for a 2.25mm 416 version if you produce it.
#29
Tech Elite
iTrader: (13)
Art sold them to anyone... I should know as I bought one
I thought it was a cool idea when I bought it but after using it I decided I could do the same thing on my setup board for free so I sold it while it was still a novelty
Nice to see a improved version of the original idea though.
I thought it was a cool idea when I bought it but after using it I decided I could do the same thing on my setup board for free so I sold it while it was still a novelty
Nice to see a improved version of the original idea though.
#30
t2 008
XRAY t2 008?