Interceptor

iTrader: (6)

Ok, in my Tamiya TA05R, esc is a Novak XRB, I have a Trinity Duo 13.5 motor that cuts out at random times. The steering still works so I'm not losing signal or anything like that, just the motor stops running after you hit the brakes and won't cut back in for several seconds. I got the motor used but it looks good as new inside and out. I took it apart to see if anything looked burnt and didn't see anything.


Edit: Its not the esc because I ran a Novak 13.5 with no problems.
Any ideas?

HUCKMAN

iTrader: (1)

Trinity is mass produced shit with their badge slapped on it! I had a duo 10.5 and it sucked! Novaks are my favorite...

Yeti35

iTrader: (5)

Funny, I am running a Trinity 10.5 Duo and it is just as fast as a Novak.

geeunit1014

iTrader: (14)

try dialing out some brake. some esc's do this when you brake hard

Ron Goetter

iTrader: (17)

I had a similar problem and it was just a bad sensor wire.

EAMotorsports

iTrader: (79)

Ditto what Ron said. the sensor wires are very fragile. The novak worked as it has its own sensor wires.

The new duo motors are awesome motors. I ran a 10.5 on asphalt and it was good.

EA