I just got a newFX-R yesterday. Got everything soldered up this morning into my Axial XR10. I am trying to calibrate it with a Flysky GT3B. Everything is set to Neutral/100%.
When I power up, bottom 3 lights are blinking. When I hold "mode"for the 3 seconds, it does the number LED4 ok, then goes to LED6 and never gets any father. It wont pick up my throttle.
Same thing with a Spektrum DX2.
My Kyosho KT-201 would get past the LED6 but then never get past LED1. I believe the trigger is bad and caused this.
Any help with the Flysky?

I just got my Hotwire. My esc was running earlier today. I connect to the Hotwire, click update esc. It says that failed and I have to recalibrate everything. When I hold the mode button to calibrate, nothing happens. All 6 lights are solid red. What do I do? Can't calibrate or connect to Hotwire.

You need to re update the esc.

Hi Drivers,

I am using RSX and use my tablet with the last software ... and I am a little bit confused with the timing advance values.
On the android app, the timing advance go from 0 to 55 Max...and if you touch the graduation appear a bubble indicating that you can set to a max of 30 degrees...

So, my question is quite simple, what is the value, in degree, of 55 ? is it 55 degrees ? or just a scale and that mean 55 = 30 degrees ?

Thx a lot by advance,

You're looking at 2 different setups.

In sensored only mode, you can boost up as high as 55, plus can timing, plus turbo.

In D2 Dual mode, you can only do up to 30 degrees of timing advance.

Thx Randy