Hot Bodies Cyclone
Tech Fanatic
iTrader: (1)
Are you drift racing ????? That might work if you are.
Rapid Racer,
I strongly reccommend you use a 1 way diff in the front and a spool in the back. You could also try square wheels and then I might out qualify you 2moro.
Seriously though I'm sure there will be a few people waiting to see how you find overdrive to the rear especially on carpet , I'll let you know how it looks after the qualifiers 2moro
I strongly reccommend you use a 1 way diff in the front and a spool in the back. You could also try square wheels and then I might out qualify you 2moro.
Seriously though I'm sure there will be a few people waiting to see how you find overdrive to the rear especially on carpet , I'll let you know how it looks after the qualifiers 2moro
Tech Apprentice
can someone confirm what Li-Po batteries fit the Cyclone without modification, or with Slight Modification to the top deck brace.
my orion 4800 fits right in
Super Moderator
iTrader: (239)
Hi!
Does anyone has any information of the new diff which was used at DHI this weekend?
http://events.redrc.net/wp-content/g...ark/HaraHB.jpg
Does anyone has any information of the new diff which was used at DHI this weekend?
http://events.redrc.net/wp-content/g...ark/HaraHB.jpg
Tech Apprentice
has anyone tried fittin the trakpower li-po packs?
Super Moderator
iTrader: (239)
Tech Elite
iTrader: (26)
steup?
does anyone know where i can find some foam setups for the WCE cyclone,
i can not find one any where, thanks if you can help me.
i can not find one any where, thanks if you can help me.
Is the left/right weight difference that big when switching from NiCD to LiPo?
How will the car drive?
How will the car drive?
Tech Regular
iTrader: (15)
Hey REVO....I know you ahve been a big user of the Trakpower packs, have you had any issues? Any performance Drops? I have been 8using a Plat 4800 with no problems but want to pick up another pack and am considering the TP 4900.....input?
Tech Elite
iTrader: (10)
Dodgy,
You have PM about setup
You have PM about setup