So I can just drill new holes?

And I am putting a yokomo chassis on a ae 12l4

thanks for the help guys

I have a helios radio and setting up my 12L4 with a hitech servo hs-225mg...and when I go into steering balance it goes all the way to 100% but it still needs more throw....The stops on the knuckles are not close to hitting or even touching for that matter..Anybody got any ideas

FIRST...do yourself an enormous favor. Ditch the HiTech servo and get a real one. I've only seen and heard horror stories about their centering (or lack thereof). That is a HUGE problem in 1/12. If you get it your experience will be forever tainted. There are SO many really good 1/12 servos out there at a range of really good prices. I'm pretty sure you can find new Futaba 9650 digital (about which I've only heard good things) for $50-60 new.

Second, not familiar with "steering balance" but are your epa's adjusted correctly. Are you using the servo saver holes closest to the saver/servo mounting screw (shortest possible arm) and/or running a steering block with more than one ball stud hole and you've chosen the hole furthest from the kingpin, or...

max your end point adjustments, reset your trims, set your dual rate to 100%

then you can begin to mount the saver to the horn.

hitech in 1/12 is death
not to bash but its so true.

The holes are not far off enough that you can drill new ones. You would have to enlarge or elongate the existing ones in the L4 brace, which would make it less effective. I would use the Yokomo brace, or just make a new one

I'd rather just use the tube brace and sand it smaller or use the CRC brace and use less shims or o-rings. That would be much easier.

I have a AE 12l4 no manual. I have a few questions.
1. Is there a specific measurement for the center shock.
2.I have all stock stuff, I's running the new JACO PRISMS do I have to get the IRS lowered POD plates and is IRS the only one selling these?
3.What's the fastest 19turn motor (over the counter) available for a long track.
4. I see guys taking motor temps at the track? I understand why however what's considered a "too hot" number?

Thanks

Can droop be adjusted on this car
Finally When will the CYCLONE12 be available?

Droop is adjusted on the front end by the amount of shims on the kingpin. On the rear it's adjusted by changing the length of the center shock.

The cyclone 12 is available right now at Stormer

https://www.ssl-stormerhobbies.com/c...ns&pn=HOT61600

Go here....
http://aedownloads.com/downloads/man...2l4_manual.pdf

Get manual.......

Does anyone know of an online shop in the U.S. that sells the Kyosho 1/12 GP SPADA 09 4WD RACING CAR?

Heck, I'd be tickled just to get one of those bodies. Those look sharp.

RC mushroom sells them for $249.99. Not too bad. I just wish they would release these in the states. I know they would be a hit. 1/8 scale action at a WAYYY cheaper price. I would get one, it's just I don't think the parts support would be there. Though I do work in a machine shop part time, and could make CF parts if I had to...