IDM Picco

Reply Subscribe

Thread Tools

Search this Thread

03-10-2007 | 10:08 AM

#31

GMartinez

Tech Champion

iTrader: (91)

Joined: Dec 2004

Posts: 8,480

From: Sunshine State

Quote:

Originally Posted by jag

This information is inconsistant with what is in the manual. The engine comes stock with a .20mm and .10mm shim (.30mm total) for use with 20-25% nitro. They recommend adding another .10mm shim (.40mm total) for 30%. Where did your information come from?

Jag for the winternats we added 2 mega shims because the dimension from the factory are not the same when you actually measure the shims it be slightly less than the manual states. I think we actually measured .45 after we added the 2 shims.
You can also call pete from pnp he also ran the IDM @ the winternat's as well

03-10-2007 | 08:20 PM

#32

memarques

Tech Rookie

Joined: Sep 2004

Posts: 7

From: Brazil

AFM

Tkx for your replay. I'll be in touch.

03-11-2007 | 03:21 PM

#33

jag

Thread Starter

Tech Master

Joined: Feb 2004

Posts: 1,168

From: So. Florida

Quote:

Originally Posted by GMartinez

All this information had me a little confused so I checked it this morning and here is what I found. With .40mm of shims (stock plus (1) .10mm shim) I have a real clearance of .57-.58mm as measured with my caliper using the "squash the solder" method. This is what Picco recommends and it is close to the clearance afm has on his chart. I am going to start here and watch closely for detonation and top speed. If needed, I will add another shim.

Thanks for the input.