Nitro Engine Break In
01-05-2007 | 10:51 PM
#47
Originally Posted by dee_vee_eight
I've just run in 2 OS Tz's that have been modded by Massive Mods, and have used his method
I think THE most important thing is as Massive says "Preheat the engine" I use a heat gun and get the motor up to near 100 deg C before I put it on the starter box. This stops it "pinching" at TDC
Good luck!
I think THE most important thing is as Massive says "Preheat the engine" I use a heat gun and get the motor up to near 100 deg C before I put it on the starter box. This stops it "pinching" at TDC
Good luck!
06-30-2009 | 03:09 AM
#49
Tech Rookie
Joined: May 2009
Posts: 1
i did the quick methord and my con rod snapped on my sh 28 but after doing some reserch i found out sh 28 have a problem with the con rod snapping i rebult it and and broke it in the slow way but i never replaced piston and sleeve but my engine is running fine now and serpsingly qucker than befor but i will admit i no abit about nitro engines i only no what i no thoug going on forums and taking my engine apart can u plz tell me if i have done some things wrong in rebluding my engine thanks 
02-22-2011 | 02:42 PM
#51
Tech Addict
iTrader: (26)
Joined: Jan 2010
Posts: 545
From: South Australia
Only problem checking the temperature using a temp gun is that they are inaccurate.
Three of us put our own temp guns to one engine and all had different readings as far out as 20deg.
So which one of the three was the nearest true reading, we never knew.
Three of us put our own temp guns to one engine and all had different readings as far out as 20deg.
So which one of the three was the nearest true reading, we never knew.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
