Rollout
#1
Rollout
I'm trying to run foams and wondering where should i start with 10/11/12 double
Thanks
Thanks
#2
23mm-25mm
#3
Re: Rollout
Originally posted by fReShJiVe
I'm trying to run foams and wondering where should i start with 10/11/12 double
Thanks
I'm trying to run foams and wondering where should i start with 10/11/12 double
Thanks
#4
i just did some searching myself
Tom - 23/24/25 is close to what i found out for 12/11/10 rollout
RCInfinity - 1/10 th scale 4WD shaft driven electric car
i also found out that i need to gear according as the tires wears down...the question is if i start with both front and rear tires the same size and the front wear out 1mm and the rear wears out 0.5mm what do i need to do with the gearing or does it need more than a gearing change??with small tires in the front is this an overdrive??what are the effects of a car being overdriven?? ....by the way i dont have any access to a tire truer so truing it back to the same size equally is out of the question
Tom - 23/24/25 is close to what i found out for 12/11/10 rollout
RCInfinity - 1/10 th scale 4WD shaft driven electric car
i also found out that i need to gear according as the tires wears down...the question is if i start with both front and rear tires the same size and the front wear out 1mm and the rear wears out 0.5mm what do i need to do with the gearing or does it need more than a gearing change??with small tires in the front is this an overdrive??what are the effects of a car being overdriven?? ....by the way i dont have any access to a tire truer so truing it back to the same size equally is out of the question
#5
Tech Elite
iTrader: (6)
Coincidentally!!! I have a new version of the gear ratio calculator on my site. I added a "target rollout" chart, which will be helpfull in figuring out what pinion to go to on a car with foams in order to maintain the same target rollout you started with (i.e. as your tire diameter decrases).
http://www.arroyoc.com/index.cfm?fus...utilities.gear
http://www.arroyoc.com/index.cfm?fus...utilities.gear
#6
HarshGuy - thank you very much ...that was really helpful...really appreciate that