Ok so mine is blue.so I purchased turbo 80\120 lcd card.doesn't work.purchased smart box,nothing...tried sub to computer.loads driver and nothing.read through all the computer tips on here and can't seem to make connection on how to install and run.just gives me this human interaction device thing.never mind,mine is a x car beast 120.

Hi
I have a problem with my trackstar smart programing box, esc gen ii 120a and a trackstar 10.5t brushless motor.

i have this combo on my trf417 and a tamiya tt02 type s.

I usually connect the programing box to the esc, to make some setup changes, but when i go to Motor Timing, it says "push to start", so i do it and then it says " sending to esc, please wait", the esc flashes once green and the red, and the time goes on and nothing happends.

i have tried taking the can timing to the minimium value, 0 and the maximium but i can not set up the motor timing.

Also i have the boost timing and the turbo timing just stock, i do not use them

I apreciate your help with this problem, i have wrote to HobbyKing and they already sent me a new smart box telling me that was the problem; i have tried this procedure with 2 or 3 smart boxes and the same happends.

Thanks for your help

Turnigy trackstar 1/12 1s gen 2, does the led flash in spec/blinky mode ? If so what color?

I need to know this too, can't seem to get blinky mode, am I missing something?

Check here: http://www.rctech.net/forum/14734227-post31.html

Which 120amp is the newest? Or better 1?

Brushless 120amp Turbo V2(aluminum case)?
Brushless gen2 120amp?

Have good luck with my 120A Trackstar and Trackstar 17.5 in my Bandit for bashing... But one suggestion, take it out of auto LVC configuration and set it to 3.0 - mine would die out after a while, and then be ok once I restarted. Figured out what the problem was while racing my SC10 with a Hobbywing ESC/Trinity D4 setup and applied it to the Trackstar, all good now

The higher the Frequency the smoother the power delivery is.


Good for low traction conditions. You will notice you have to apply more throttle input for the same speed you are use too. I like 8KHZ which is default setting. Same for the brake frequency .

I have a trackstar turbo v2. The throttle cuts in & out??

Only have had v1's. The only time mine ever did this was if I had the turbo set to high. I think it would over clock past 60' and cause it to stop then all of a sudden accelerate again.

I would take out all timing and just use the endbell first. If that fixes it then add boost/turbo slowely.


Also could be the low voltage cutoff is to sensitive. Try lowering to a minimum.

Hi - I have 2 Turnigy Trackstar Turbo 80a esc and I am facing following issue on both : when I go reverse, I can not go forward before the car stops. This is a big issue as there is no way to brake before car stops by itself. Note that I do not have this issue with my other esc and I have done proper calibration on both.

How can I change the settings to avoid this ?

Thanks
Julien

You need to reverse the throttle channel on your radio and recalibrate the esc to it.

I tried but I can not calibrate it forward once I reverse the throttle channel.

Bummer. What tx and rx are you using?

Both are Spektrum