I'll have to order one

Here's the difference between std chassis and et48.3. Proline Raptor vs LST2 XXLE body.

For my personal preference, I like the ET48.3 chassis much better in terms of looks.

Thanks for that comparison shot. Crazy how they change the entire wheelbase with just the rear of the chassis. The truggies I've converted to SWB lose a little bit in both the front & rear of the chassis.

Tekno has it right with the parts compatibility. Everything snapped on perfectly. Took like 15 mins to swap chassis.

It arrived early and have to share in my excitement. Likely wont crack into this till next weekend but at least it's here.

Nice!

You'll notice that the Losi XXLE body is a lot stronger than most bodies. I did the E6000/Shoe-Goo and Dray Wall Tape treatment as well. It's tough as nails now.

I have the same tires on my RC8T-MT with the Trencher X 3.8 and they do rub a little in the front when they ballon. You may have to trim some of the front fender.

Congratulations!

I see that, I think you got the last chassis

Looks awesome! I'll get the parts to try when in stock.

When I purchased. It was two chassis in stock. So it should of been 1 left after my purchase.

Someone liked your images...

LOl maybe

I ordered mine on Tuesday, hopefully should be here next week fingers crossed.

What pinions are you guys running?

Congrats. From what I have seen they look like an easy build and Tekno quality.

For me I am starting with a 15T on 4S with a HW 2200kv and TA Rival Rims/Tires. Will temp and gear it for 6S in the end.

Question? Is anyone going to put a wing on theirs? I would think the ET48.3 would fit maybe.

I ordered this to try: https://www.amainhobbies.com/tekno-r...kr5181/p443639. Was a bit of a gamble between that or the regular set, we'll see how it works out when it gets here.