You did it greatly.

Nice. Cant wait to see more.

If things go right more video will get made tomorrow. Going to take the p401 and the ascender out for comparison run on more than my driveway lol.

Well I got rained out.so I well try tomorrow!

Video is uploading now. Soon as its done I'll post the link.I have the P401 crawling some rough rocks.found some flaws but honestly I was impressed. I ran it as it came out the box. Next run I'll address a few issues. This video also shows my ascender on the same terrain

Can't wait to see this.

https://youtu.be/xCQJ-3_dS3o

+ YouTube Video

So here it is.sorry for the delay. ..connection speed is slow.

You will need to change the video setting from private to public before people can view it.

Sorry bout that folks. It is public viewing now

So all in all after running the p401 I would say it's capable. It's not perfect out of the box but I haven't seen a rtr that was. Since my run I have removed the 2.8s on it and replaced with axial ripsaws. They are about half as wide as the stock ones.should allow a bit more suspension travel without rubbing the body or snagging the bumper. And im working on a Panhard setup for the front. It loses a bit of steering to front end shift. But it showed it could get around just fine.

Looks good. I like the video. Jealous I cant be wearing sandles still too damn cold.

Lol. We still see 100 degrees during the heat of the day

You can write a detail review article with more big and beautiful picture
It will be nice!

I already have. There's 2 or 3 of them in my thread

Well I'm hoping to get the 401 out this weekend. I did remove the huge rtr tires and downsized to axial ripsaws. Like to try it out. I think it'll cover the fender and bumper rib